1
ROLL
VOLUME
1
Remove the nut that holds down the roll volume bracket, then remove volume from roll volume bracket and
replace it.
The wire connected to the volume is used as is. Cut away the thermal contraction tube with nippers or cutter,
melt the soldered areas with a soldering iron and remove wire from the volume.
10
Cover the soldered areas with the thermal contraction tube. In place of the thermal contraction tube that was
cut away, pass each wire through new thermal contraction tube.
11
Solder the wire to the new volume. Check the wiring diagram to be sure there are no errors in wiring.
1
Cover the soldered areas with thermal contraction tube. Heat the thermal contraction tube with an industrial
drier so that the tube adheres to soldered areas.
1
Attach the gear and roll volume bracket to volume.
1
Rotate the gear so that the D cut surface of the volume shaft is level, facing directly upward.
1
Attach the roll volume bracket so that the seat is level and the gear does not rotate. Tighten the 2 fastening
screws. Adjust the gear mesh at this time.
1
Connect the connector and fasten wire with cord clamps.
1
Attach the front pillar cover.
1
Turn on the power. Note that initialization takes place.
1
Establish volume settings on the game test mode calibration screen. (See 9-3e.)
0
Simply changing the settings on calibration screen will not be effective. Terminate the test mode. Note that
initialization takes place when test mode has been terminated.
FIG. 13-2h Volume Replacement
Summary of Contents for AFTER BURNER CLIMAX
