Seg SP760 Series, Instruction Manual

Page: 33 / 41

Smart Positioner
SP760 Series
Ver 1.0 SHINHWA Eng.
- 32 -
If increasing 100% ->0%, the operation velocity is adjusted to the target position.
It is normally used when velocity is too far fast due to small actuator or
when load friction shows down the lowering velocity .
<ENTER 5 sec
+UP 2 times
→
<ENTER>
<UP>/<DOWN>
→
<ENTER>
→
<ESC 3
times>
→
7-7 Hand Calibration Mode (HAND CALL)
HAND CAL mode is used to require on automatic set position or parameter value
change after executing AUTO CAL mode. And also it is used when requiring to
change into Zero point and End point.
7-7-1 SV NORM
Positioner's SV values can be same or reverse output with the actual open.
EX ) if NORM input 4mA =0% open, If REV input 4mA =100% open.
<ENTER 5sec
+UP 3 times>
→
<ENTER>
<UP 1 time>
→
<ENTER>
→
<UP>/<DOWN>
<ENTER>
→
<ESC 3
times>
→
7-7-2 DP NORM