53
5.11.8
Test Dialer
Special function is provided to test the dialer operation. This function can manually test both
the phone line L1 and L2 and also reset the dialer where all the events to be reported in the
queue are cleared and the dialer status is reset.
5.11.9
After Hours
This operation allows to manually set the daytime or the night time mode of operation thus
over-riding the current daytime or nighttime mode. The user is prompted for confirmation as
shown below:
After the confirmation the user is prompted to enter which mode to be set.
After the user selection and information message is displayed that the daytime nighttime mode
is updated.
5.11.10
Clear Verify Count
This operation is used to clear all the verification counts accumulated during the alarm
verification process. The user is prompted for confirmation as shown below:
After the confirmation the verification count is cleared and the information message is
displayed that the counts are cleared.
5.11.11
Ground Fault Test - Factory Use Only
Displays the system ground fault, positive and negative. When ground fault test is selected,
your passcode will be requested. An example of a ground fault test result is shown below.
---Dialer test ----
1. L#1 manual test
2. L#2 manual test
3. Reset dialer
Manual night mode
Change ?Y/N
Select mode
1. Daytime
2. Night time
Day/night mode
updated
Clear all verif
Counters ?Y/N
Verify
Counters cleared
Summary of Contents for MR-401
Page 2: ......
