S4i PERS User Guide
Press to start
an emergency
call.
Right light:
Blinking
: alarm in
progress
On
: message
acknowledged
Press to cancel
an emergency
call
Shows power
status
Shows communication
status
Shows problem
status
·
On
: AC power
connected
·
Green
: if on, ready for call. If
blinking, message being sent.
·
On
: malfunction in the
control panel or a
peripheral
·
Blinking
: Operating
on battery. Mains
power failure
·
Red
: if on, failure in cellular
network. If blinking, cellular
reception is poor
·
Blinking
: supervision
lost, or low battery in a
peripheral
·
Off
: no power
·
Orange
: active conversation
· Call the support centre
if this light is on for more
than 15 minutes
Turning the s4i PERS Alarm On
The On/Off button is recessed into the bottom of the panel as per the
diagram below. Ensure the power cable is connected correctly and the plug
pack is connected to a reliable power point and where the power supply
will not get knocked out. Fit the back cover on.
Backup battery
Connect the power cable
and plug into a power
source. Then close the back
cover.
Turn the power switch
ON
For assistance call Securely on 0800 865 865
