158
Step 4: Telephony Service Cutover
Digital TDM Spans
For each Card in the Appliance, connect telco cables to each licensed
Span as follows:
Span 1—Port 1 to CO, Port 2 to PBX.
Span 2—Port 3 to CO, Port 4 to PBX
Span 3—Port 5 to CO, Port 6 to PBX
Span 4—Port 7 to CO, Port 8 to PBX
ETM 5000 Series
See the
ETM
®
5000 Series SIP Appliance Installation and Configuration
Guide
.
Upon initial configuration, digital Spans come up offline so that you can
configure telco settings without disrupting your traffic. After Spans are
configured and you connect the telco cables, place the Spans inline.
To place the Spans inline
Type the following series of commands via a Console connection or the
ASCII Management Interface
for the Span.
SPAN INLINE
RESTART
To open the ASCII Management Interface for one or more Spans
In the Performance Manager tree pane, right-click the Span, and then
click
ASCII Management
. To select multiple Spans, hold down
CTRL, click each Span, and then right-click the selection, and then
click
ASCII Management
.
Follow the applicable instructions below to verify operation after
performing cutover.
"Verifying ETM® 1090/2100/3200 Appliance Operation" on page 159.
"Verifying ETM® 1012/1024 Appliance Operation" on page 160.
SS7 Signaling Link
Cards only use ports 1
and 2.
Placing Digital
Spans Inline
Post-Cutover
Verification
