T/049A/SBL340
5
th
January 2017
SBL340
Installation Instructions for SBL340 Push Button Lock with Deadbolt
This lock has been Fire Tested in accordance with BS EN1634-1 with the use of Intumescent Seals.
Installation
Applying the Template
Correctly position and tape the template, T/048/SBL340, to the internal door face, at the desired
height from the floor level. Ensure that the marked door edge on template is correctly aligned with
actual door edge. (Figure 1)
Mark the 10mm diameter hole for the spindle of the Digital Lock, the two 7mm holes for the bolt
through fixings.
Drill all marked holes.
Handing Digital Lock
IMPORTANT:
Firstly determine handing of the door. When viewed from the outside, your door is right handed if the hinges are on
the right and left handed if the hinges are on left.
NOTE:
The Knob on the external Keypad Digital Lock will rotate freely in one direction and require the inputting of the code to
rotate in the other direction; this is allows the deadbolt to be thrown from the outside
without a code entry but not withdrawn.
Remove the cover held in place by 2 blue screws.
With Tweesers remove the metal pin and put in the other visible hole to change
handing.
Replace cover and secure using blue screws.
The metal pin will only locate in the back of the digital lock unit properly if the follower
is in the correct orientation (as shown in the images on the right).
If you do not reinsert the metal pin in to either of the holes then the deadbolt can be
thrown and withdrawn from the outside without the entry of a correct code.
Positioning of Spindle
The spindle is designed for doors 35 to 65 mm thick. Therefore shorten, if
necessary, to suit door thickness
When inserting the spindle correctly locate it into the reverse of the Digital
Lock with consideration to the handing of the door. (Figure 4)
Fixing the Lock
IMPORTANT:
Do not close the door before confirming that the code and lock is functioning correctly.
If necessary, shorten the fixing bolts in order to suit the thickness of the door
When shortening the fixing bolts allow at least 4/5 threads to screw into the lock case
Figure 1
Figure 4
Door edge
BEFORE INSTALLATION
PLEASE:
1) Ensure all parts work
properly
2) Check and Ensure the
supplied Code works. If you
wish to change the code follow
the instructions under
‘Changing the Code’ and
confirm at it works.
3) Ensure that both knob
handles of the Digital Lock can
be moved freely. Also check
that the deadbolt moves freely
by throwing and withdrawing it
using the knob on the internal
block.
LIST OF PARTS
1) Digital Lock with Knob
Handle
2) Internal Block with
Deadbolt
3) Neoprene Seals x 2
4) Spindle
5) Mortice Keeper
6) Surface Mounted Keeper
7) Wood screws x 2 (For
securing Keeper)
8) Tweesers (
For changing the
Code)
9) Fixing Bolts x 3 (1 spare)
10) Spare Code Tumblers
11) Code Card
