T/043/SBL320
17
th
October 2013
SBL320
Installation Instructions for SBL320 Push Button Lock with Knob Handle
This lock has been Fire Tested in accordance with BS EN1634-1 with the use of Intumescent Seals.
Setting/Changing the Code
On the reverse of the Digital Lock Unit you will see slotted buttons which correspond to
the push buttons on the front of the Lock.
To set a button to operate within the code turn the slotted button relating to the number
so that the dot is facing inwards (towards the ‘F’)
To take a button out the code turn the slotted button so the dot is facing outward
(towards the ‘G’)
Check the code on the Lock functions before fitting to the door.
Installation
Applying the Template
Correctly position and tape the template, T/034/SBL320, to the internal door face, at the
desired height from the floor level. Ensure that the relevant, marked, door edge on
template is correctly aligned with actual door edge. (Figure 1)
Mark the 10mm diameter hole for the spindle of the Digital Lock, the two 7mm holes for
the bolt through fixings.
Mark the correct 6mm diameter hole, for the reinforcement pin, depending on the handing
of the door.
Drill all marked holes.
Applying the Intumescent Seals
IMPORTANT:
In order for this unit to maintain its fire rating status and be suitable to be installed on a fire rated door
Intumescent Seals
must
be used. A 2mm self-adhesive
mono-ammonium phosphate (Interdens)
intumescent seal
is recommended.
Using the intumescent seal wrap the barrel of the tubular latch in one uniform layer
Affix one 2mm intumescent layer behind forend of latch and behind the rear of the striker prior to installation.
Figure 1
Door edge
BEFORE INSTALLATION PLEASE:
1) Ensure all parts work properly
2) Choose and set a code following the
“Setting/Changing the Code” instructions.
All or part of the push-buttons can be
chosen in no particular order. Codes with 4
digits provide maximum security
3) Ensure that both knob handles of the
Digital Lock can be moved freely. Check
that the Hold Back function can be engaged
and keeps the latch retracted and handle
pressed. Also check that the latch moves
freely by pressing the end and by turning
with
the spindle
LIST OF PARTS
1) Digital Lock with Knob
Handle
2) Internal Block
3) Neoprene Seals x 2
4) Spindle
5) Latch (60mm standard)
6) Striker Plate
7) Wood screws x 4 (For
securing Latch and Striker
Plate)
8) Bolt Guide
9) Fixing Bolts x 3 (1 spare)
