Chapter 4: Using Your Device
Page 62
Chapter 4:Using Your Device
Setup Instructions
To set up the equipment for use you will need to:
1.
Charge the battery
2.
Insert the battery into the VPU
3.
Connect the glasses to the VPU
4.
Put on the VPU
5.
Put on the glasses
Charge the battery.
Before using the battery for the first
time, charge it fully. To insert the battery into the
charger, push the round end of the battery against the
spring in the middle of the battery slot. Pushing the
spring away from the charger’s power cable, push down
until the battery is in the charging slot. When inserting
the battery, ensure that the battery is fully seated in the
charger before letting go of the battery. This will prevent
the battery from popping out of the charger. A digital
display on the charger indicates when the battery is
charged. It takes 3-4 hours to fully charge a discharged
battery. A sighted individual can check if the battery is
fully charged.
