Now select the desired unit for temperature - °C or °F - by turning the rotary knob to the
desired unit and confirm by pressing.
This initial setup will no longer be displayed when switching the transfer heat press on in
the future.
To reset the HPC01 controller to factory settings, simultaneously press the
button as well as the
button for 3 seconds.
Setting the temperature
Briefly press
, the symbol in the display begins to flash. The value in the
display changes from the current ACTUAL value to the TARGET value, which can
now be set. Turn clockwise to increase the TARGET temperature, counter-clockwise
to decrease. Press the rotary knob or press
to store the set value. If no input
occurs for 5 seconds, input mode ends automatically. Pressing
exits input mode,
the set value is not applied and the display returns to the current ACTUAL value.
Temperature-related indicators
is activated whenever the heater is running.
During the warm-up phase, every 10s an estimated remaining warm-up time scrolls across
the display for 3s instead of the current temperature.
is activated when the actual temperature is equal to the target temperature, with a
certain deviation of less than +/- 3 °C.
Arrow up is activated when the temperature is rising (if below TARGET temperature,
arrow is blinking), arrow down is activated when the temperature is dropping, e.g. during a
transfer or if the heat plate is still hotter than the set target temperature.
Secabo GmbH Hochstatt 6-8 85283 Wolnzach Germany [email protected] www.secabo.com
9
