In
Pos 0
(normal flight) this mixing need to be activated, ON.
In
Pos 1
(full rates) this mixing need to be dis-activated, OFF.
In
Pos 2
(3D & hovering) this mixing need to be dis-activated, OFF.
Full Aileron RIGHT & full Aileron LEFT → elevator DOWN 10%
This mixing will help to perform at normal and fast speed very axial rolls.
In
Pos 0
(normal flight) this mixing need to be dis-activated, OFF.
In
Pos 1
(full rates) this mixing need to be activated, ON.
In
Pos 2
(3D & hovering) this mixing need to be activated, ON.
Full elevator UP → vektor 1 UP 100%
Full elevator DOWN → vektor 1 DOWN 100%
This mixing is necessary for the 3D flying.
In
Pos 0
(normal flight) this mixing need to be dis-activated, OFF.
Summary of Contents for Mig-29 3D EDF ARF
