Seat Toledo 2019, Owner'S Manual, Page: 226 / 300

Driving
traffic. There must be good weather and
light conditions.
● The volume and tone of the warnings can
be modified, in addition to the indications
›››
page 227 .
●
In vehicles without a driver information
system, these parameters can be modified
in a SEAT Official Service or in a special-
ised workshop.
●
Please observe information on towing a
trailer
›››
page 227 .
● The display on the Easy Connect screen
shows a slight time delay.
Rear parking aid*
The rear Parking Aid assists the driver in park-
ing by means of audible warning sounds.
Description
There are sensors integrated in the rear
bumper. When the sensors detect an obsta-
cle, you are alerted by audible warnings.
Make particularly sure that the sensors are
not covered by adhesives, residues and the
like, as this could affect the system's opera-
tion. Cleaning instructions
›››
page 267 .
The approximate measurement range of the
rear sensors is:
side area 0.90 m
central area 1.60 m
As you approach the obstacle, the time inter-
val between the audible warnings will be re-
duced. When you reach around 0.30 m the
warning will be constant: Do not continue to
move forward (or backward)
›››
in General
information on page 223 ,
›››
in General
information on page 223 !
If you maintain separation from the obstacle,
the volume of the warning begins to reduce
after four seconds (does not affect the tone
of the constant warning).
Activating/Deactivating
When engaging reverse gear, the parking aid
is automatically switched on. This is con-
firmed with a short warning.
On disengaging reverse gear, the Parking Aid
system is disconnected immediately.
Parking aid plus*
Fig. 226
Represented area.
Parking system plus assists you audibly and
visually when parking.
There are sensors integrated in the front and
rear bumpers. When they detect an obstacle,
you are alerted by audible warnings and vis-
ually on the Easy Connect system.
In the event of danger of a frontal collision,
the audible warnings come from the front of
the vehicle, and in the event of the danger of
a rear-end collision they come from the rear.
Make particularly sure that the sensors are
not covered by adhesives, residues and the
like, as this could affect the system's opera-
tion. Cleaning instructions
›››
page 267 .
The approximate measurement range of the
sensors is:
1.20 m
A
224