Seat Toledo 2019, Owner'S Manual, Page: 205 / 300

Start and driving
If the control lamp

flashes, the ASR is work-
ing.
If the

warning lamp illuminates on ignition,
the TCS system may have switched off due to
technical reasons. Turn off the ignition and
turn it on again. Upon switching on the igni-
tion again, if the warning lamp has switched
off, this means the TCS is functioning correct-
ly again.
If the

warning lamp remains illuminated,
there is a fault in the TCS.
The informative display indicates:
Fault: traction control system
(ASR)
Go to a technical service.
Electronic differential lock
If one of the wheels starts to skid, the EDL
brakes that wheel, transmitting the driving
force to the other wheels. This increases vehi-
cle stability and improves driving stability.
To prevent the disc brake of the braking
wheel from overheating, the EDL cuts out au-
tomatically if subjected to excessive loads.
The vehicle will continue to function normally
without EDL. The EDL will switch on again au-
tomatically when the brake has cooled down.
Manual gearbox
Changing gears
Fig. 215
Gear shift diagram of a 5- or 6-speed
manual gearbox
Read the additional information carefully
›››

page 36
When changing gear, always depress the
clutch pedal fully and keep it pressed down
to avoid excessive clutch wear.
In order to drive at an optimum RPM, follow
the gear change indications
›››
page 208 .
Engage reverse gear only when the vehicle is
stopped. On engaging reverse gear while the
engine is running, first wait a moment with the
clutch pedal pressed down fully to limit gear
shift noise.
The reverse lights switch on when the reverse
gear is selected and the ignition is on.
WARNING
Never engage reverse gear when moving
forward. Risk of accident!
Note
Do not rest your hand on the gear lever
while driving. The pressure of your hand
could lead to premature wear of the gear
system.
Automatic gearbox
Basic information
The gearbox changes up and down automat-
ically. The gearbox can be set to
Tiptronic
mode. The gears can be changed manually
in this mode
›››
page 206 .
The engine can be started only in position P
or N . If the selector lever is not in these posi-
tions when locking the steering, switching the
ignition on or off or starting the engine, the in-
formation display will show
¡Move the se-
lector lever to the P/N!
position, or on
the general instrument panel

P/N
.
At temperatures below -10°C (14°F), the en-
gine can only be started in position
P .
If you park your vehicle in a flat surface, move
the selector lever to position
P . On a slop, first
»
203