Seat Tarraco 2020, Owner'S Manual, Page: 284 / 424

Driving
The following conditions may lead the
ACC not to react:
●
If the accelerator is pressed.
●
If there is no gear engaged.
●
If the ESC is controlling.
●
If the driver is not wearing his/her seat belt.
●
If several brake lights of the vehicle or elec-
trically connected trailer are damaged.
●
If the vehicle is reversing.
●
Driving faster than 210 km/h (130 mph).
Driver messages

ACC not available
●
The system cannot continue to guarantee
safe vehicle detection and is deactivated.
The sensor has lost its setting or is damaged.
Take the vehicle to a specialised workshop
and have the fault repaired.

ACC and Front Assist: currently
not available. No sensor vision
●
This message is displayed if the radar sen-
sor's visibility is impaired by leaves, snow,
dense fog or dirt. Clean the sensor
›››
Fig. 264 .

ACC: currently not available.
Gradient too steep
●
The maximum road slope has been excee-
ded, hence safe ACC operation cannot be
guaranteed. The ACC cannot be switched
on.

ACC: only available in D, S or M
●
Select the D/S or M position on the selector
lever.

ACC: parking brake applied
●
The ACC is deactivated if the parking brake
is applied. The ACC is available once again
after the parking brake is released.
 ACC: currently not available. In-
tervention of stability control
●
The indication is displayed when the elec-
tronic stability control (ESC) intervenes. In this
case, the ACC is automatically switched off.

ACC: Take action!
●
The indication is displayed if, when the ve-
hicle starts up on a hill with a slight slope, the
vehicle rolls back even although the ACC is
activated. Apply the brake to stop the vehicle
from moving/colliding with another vehicle.
 ACC: speed limit
●
The indication is displayed in vehicles with
manual gearboxes if the current speed is too
low for the ACC mode. The speed limiter
switches off if the speed falls below 20 km/h
(12 mph).
 ACC: available as of the 2nd gear
●
The ACC is operational as of the 2nd gear
(manual gearbox).

ACC: engine speed
●
This indication is displayed if, when the
ACC accelerates or brakes, the driver does
not shift up or down a gear in time, which
means exceeding or not reaching the permit-
ted RPM. The ACC switches itself off. A buzzer
warning is heard.

ACC: clutch applied
●
Vehicles with manual transmission: pressing
the clutch pedal for longer exits cruise con-
trol.
Door open
●
Vehicles with automatic transmission: the
ACC cannot be activated with the vehicle
stationary and the door open.
WARNING
There is a danger of rear collision when the
distance to the vehicle in front is reduced
and the speed difference between both ve-
hicles is so great that a speed reduction by
the ACC is not sufficient. In this case, brake
immediately!
●
The ACC may not be able to detect all
situations properly.
●
Stepping on the accelerator may cause
the ACC not to intervene in braking. Driver
282