Seat Tarraco 2020, Owner'S Manual

Page: 153 / 424

Transport and practical equipment
work at a maximum power of up to 10.5 W per
port.
They are not intended for file playback.
230 volt power socket*
With the engine running, the power socket
›››
Fig. 151 activates automatically as soon as
a connector is plugged in. If there is enough
power available, the socket can still be used
while the engine is off
›››
Connect an electrical device: Open the cov-
er and insert the plug into the power socket
as far as possible to unlock the built-in child
lock. The socket only supplies power once
the child lock is unlocked.
LED on the power socket
Steady green
light: The childproof lock is unlocked.
The socket is ready to operate.
Flashing green
light:
The ignition is switched off, but
there is enough power available
to continue supplying the socket
with current for a maximum of 10
minutes. If the connector is un-
plugged before this time elap-
ses, the socket is disconnected
and cannot be used again until
the ignition is switched on again.
Flashing red
light:
There is an anomaly, e.g. dis-
connection due to a current
surge or overheating.
Disconnection due to overheating
When the temperature exceeds a certain val-
ue, the 230 volt socket inverter is automati-
cally disconnected. The disconnection pre-
vents overheating when the power consump-
tion of the connected devices is excessive or
the ambient temperature is very high. The
230-volt power supply can be used once
again after a cooling time. First unplug the
connector of the connected device and then
plug it back in again. This prevents the elec-
trical device from being switched on again if
this is not wanted.
WARNING
The electrical system is under high voltage!
●
Do not spill liquids onto the socket.
●
Do not plug adapters or extension cords
into the 230 volt power socket. Otherwise,
the integrated child lock will be unlocked
and the power socket will operate.
●
Do not insert conductive objects (a knit-
ting needle, for example) into the 230 volt
power socket.
WARNING
The power socket works only when the igni-
tion is on. Improper use may cause serious
injury or even fire. Children should there-
fore not be left in the vehicle unattended if
the button is also left behind. Otherwise
there is a possibility that they may be in-
jured.
CAUTION
Always use the correct type of plugs to
avoid damaging the sockets.
CAUTION
●
230 volt power socket:
–
Do not leave devices or connectors
that are too heavy (e.g. a transformer)
hanging directly from the power sock-
et.
–
Do not connect neon lamps.
–
Only connect devices to the socket if
the device and socket voltage match.
–
The built-in overload disconnect func-
tion prevents any electrical devices
that require a high start-up current
from turning on. In this case, unplug the
electrical device's power supply and
re-try the connection after about 10
seconds.
Note
●
The use of electrical appliances with the
engine switched off will cause a battery
discharge.
● Should the connected appliance over-
heat, immediately switch it off and discon-
nect it from the socket.
»
151