Seat Media System Plus, Owner'S Manual, Page: 9 / 64

Introduction
The infotainment buttons are operated by
pressing them or holding them down.
Switching on and off
To switch the unit on or off manually, briefly
press the rotary knob

›››
Fig. 1
1
.
When you connect the system it will play at
the volume at which it was last set, provided
it does not exceed the maximum permitted
volume
›››
page 54 .
The unit will switch off automatically when
the vehicle key is removed. If you turn the
unit back on after the engine has been
switched off, it will turn off automatically af-
ter approximately 30 minutes (delayed
switch-off).
Note
●
The unit is linked to the vehicle. It cannot
be used in any other vehicle.
●
When the vehicle battery is disconnected,
you must turn ignition on before switching
the unit on again.
Adjusting the base volume
Function Action
Increase
the vol-
ume. Turn the volume control

clockwise or
turn the right thumbwheel roller upwards
on the multifunction steering wheel
›››
Booklet Instructions manual .
Lower the
volume. Turn the volume control

anticlockwise
or turn the right thumbwheel downwards
on the multifunction steering wheel.
The volume modification is shown on the
screen with a bar. During this time the unit
cannot be operated.
It is possible to preset certain volume set-
tings and adjustments
›››
page 54 .
Silence the unit
● Turn the volume control

anticlockwise
until you see

.
● ALTERNATIVELY: Press the
MUTE
infotain-
ment button.
Note
If the basic playback volume of an audio
source has been increased substantially, low-
er the volume before changing to another au-
dio source.
Operating the function buttons on-
screen
Fig. 2
Standard representation: setup menu
list entries.
Fig. 3 Standard representation: sound setup
menu.
The unit is equipped with a touchscreen.
»
7