Seat 2014 LEON CUP RACER, Owner'S Manual

Page: 82 / 284

Operation
Service interval display
Service interval display
The service interval indication appears on the
instrument panel display
›››
Fig. 82
4
.
SEAT distinguishes between services with en-
gine oil change (e.g. Oil change service) and
services without engine oil change (e.g. In-
spection).
In vehicles with Services established by time
or mileage , the service intervals are already
pre-defined.
In vehicles with LongLife Service , the inter-
vals are determined individually. Technical
progress has made it possible to considera-
bly reduce servicing requirements. The tech-
nology used by SEAT ensures that your vehi-
cle only has an Oil Servicing when it is neces-
sary. To establish when the oil servicing is
due (max. 2 years), the vehicle's conditions
of use and individual driving styles are con-
sidered. The service pre-warning first ap-
pears 20 days before the date established for
the corresponding service. The kilometres
(miles) remaining until the next service are
always rounded up to the nearest 100 km
(miles) and the time is given in complete
days. The current service message cannot be
viewed until 500 km after the last service. Pri-
or to this only lines are visible on the display.
Inspection reminder
When the Service date is approaching, when
the ignition is switched on a
Service remind-
er is displayed.
In vehicles without text messages, a spanner
is displayed on the instrument panel

with
a figure given in km . The number of kilome-
tres shown is the maximum number that may
be driven until the next service. After a few
seconds, the display mode changes. A clock
symbol appears and the number of days until
the next service appointment is due.
In vehicles with text messages,
Service in ---
km (miles) or --- days is displayed on the in-
strument panel.
Service due
After the service date , an audible warning is
given when the ignition is switched on and
the spanner displayed on the screen flashes
for a few seconds

. In vehicles with text
messages,
Service in --- km or --- days
is dis-
played on the instrument panel.
Reading a service notification
With the ignition switched on, the engine off
and the vehicle at a standstill, the current
service notification can be read:
Press and hold the button
›››
Fig. 82
4
for
more than 5 seconds to consult the service
message.
When the service date has past , a minus sign
is displayed in front of the number of kilome-
tres or days. In vehicles with text messages
the following is displayed:
Service --- km
(miles) or --- days ago .
The time can also be set via the

key and
Setup
function button in the Easy Connect
system
›››
page 81 .
Resetting service interval display
If the service was not carried out by a SEAT
dealership, the display can be reset as fol-
lows:
● To reset the service interval display, turn
the ignition off and press and hold the but-
ton
›››
Fig. 82
4
.
●
Switch the ignition back on.
● Release the button
›››
Fig. 82
4
and press
the button
4
again for the next 20 seconds.
Note
● The service message disappears after a few
seconds, when the engine is started or when
OK/RESET
is pressed on the windscreen wiper
lever, or
OK
on the multifunction steering
wheel.
●
In vehicles with the LongLife system in
which the battery has been disconnected for
a long period of time, it is not possible to cal-
culate the date of the next service. Therefore
the service interval display may not be cor-
rect. In this case, bear in mind the maximum
80