Seat 2014 LEON CUP RACER, Owner'S Manual

Page: 36 / 284

The essentials
● Remove the lid from the filling tube
›››
Fig. 50
3
and screw the open end of the
tube into the tyre valve.
● With the tyre sealant bottle upside down,
fill the tyre with the contents of the sealant
bottle.
● Remove the bottle from the valve.
● Place the insert back into the tyre valve us-
ing the tool
›››
Fig. 50
1
.
Inflating the tyre
● Screw the compressor tyre inflator tube
›››
Fig. 50
5
into the tyre valve.
● Check that the air bleed screw is closed
›››
Fig. 50
7
.
● Start the engine and leave it running.
● Insert the connector
›››
Fig. 50
9
into the
vehicle's 12-volt socket
›››

page 113 .
● Turn the air compressor on with the ON/OFF
switch
›››
Fig. 50
8
.
● Keep the air compressor running until it
reaches 2.0 to 2.5 bar
(29-36 psi/200-250 kPa).
a maximum of 8
minutes .
● Disconnect the air compressor.
● If it does not reach the pressure indicated,
unscrew the tyre inflator tube from the valve.
● Move the vehicle 10m so that the sealant is
distributed throughout the tyre.
● Screw the compressor tyre inflator into the
valve.
● Repeat the inflation process.
● If the indicated pressure still cannot be
reached, the tyre is too badly damaged. Stop
and request assistance from an authorised
technician.
● Disconnect the air compressor. Unscrew
the tyre inflator tube from the tyre valve.
● When the tyre pressure is between 2.5 and
2.0 bars, continue driving without exceeding
80 km/h (50 mph).
● Check the pressure again after 10 minutes
›››

page 222 .
 ›››
in TMS (Tyre Mobility System)* on
page 221

›››
page 221
With spare wheel
Fig. 51
See Fig. for positioning 2
Fig. 52
Jack anchor points
An adapter for the anti-theft wheel bolts*
Towline anchorage
Box spanner for wheel bolts*
Crank handle for jack
Jack*
1
2
3
4
5
34