1
Tools Required:
Large Phillip's Head Screwdriver
1/2 Socket or Wrench
Hammer
(43) Traditional Picnic Table rev. A
WOOD
ENVIRO
S
EASIDE
C
ASUAL
F
URNITURE
Hardware:
(28) 3-1/2” Truss 5/16” Bolts
(27) 4-1/2” Carriage 5/16” Bolts
(55) Nuts
(55) Flat Washers
(2) Table Slats with 3 holes (Aluminum Reinforced)
(2) Table Slats with 5 holes (Aluminum Reinforced)
(1) Center Table Slat with Umbrella hole (Aluminum
Reinforced)
(4) Legs
(1) Table Center Cleat with 2 holes
(2) Table End Cleats with 4 holes
Assembly Instructions
Step One: Set Up
READ ENTIRE INSTRUCTIONS BEFORE BEGINNING!
Carefully remove contents
from box. Make sure that all parts and hardware are included.
Place All Table Slats face down with Aluminum facing up
on a flat clean surface. Follow the following list for place-
ment.
1st Slat (Far Left)= Table Slat with holes #1,#6,#11
2nd Slat (Middle Left)= Table Slat with holes #2,#7,#12
3rd Slat (Middle)= Center Table Slat with holes #3,#8,#13
4th Slat (Middle Right)= Table Slat with holes #4,#9,#14
5th Slat (Far Right)= Table Slat with holes #5,#10,#15
(Right Picture)
Step Two: Table Slat Placement
WARRANTY QUESTIONS OR COMMENTS PLEASE CALL TOLL FREE AT 1-800-809-3114
Parts List
(4) Seat Slats with 2 holes (Aluminum
Reinforced)
(4) Seat Cleats
(2) Angle Braces
(2) Seat Supports
Box 1:
Box 2:
Instruction Revision: B
11 12 13 14 15
6 7 8 9 10
1 2 3 4 5
