MAINTENANCE
3. Align the motor shaft so the flat section on the shaft is
lined up with the flat area on the inside of the impeller.
Slide the pump end with the insert and impeller onto the
motor shaft.
4. Insert the O-Ring and cover plate. Make certain that the
O-Ring remains seated in the groove.
5. Secure the assembly with the two cover screws. Tighten
these evenly, but do not over-tighten the screws.
Typical uses for the Utility Pump:
Pump out a flooded basement.
Empty a clogged sink or tub.
6
629 0405
IN
OU
T
IN
OU
T
Figure 8 – Install Pump End
Figure 9 - Install Cover Plate
