10
OPERATION INSTRUCTION
SQUEEGEE SP300
BEFORE STARTING ENGINE:
1.
Follow the maintenance procedures listed in the engine manual.
2.
Check the gas supply.
3.
Make sure the control lever #42, located at the left of the
steering wheel, is in the neutral position. Along with the 3 levers
#H10 #H14 #H15 to the right of the steering wheel.
TO START ENGINE:
4.
Position yourself in the operator’s seat.
5.
Push the throttle lever #34, located at the left of the steering
wheel, 1/3 of the way.
6.
COLD ENGINE: Pull choke knob #33, located on the control panel,
left of the steering wheel, all the way out and turn ignition switch
#1 If the engine does not start, repeat this procedure. Use the
choke moderately. Allow the engine to warm up before
operating.
7.
WARM ENGINE: It should not be necessary to use the choke
when the engine is warm. However, this may vary with each
engine. This will require the operator to become familiar with the
unit.
TO OPERATE MACHINE:
8.
To move the machine forward, push control lever #42 forward
SLOWLY
until your desired speed is reached. To move the
machine in reverse, pull the control lever to neutral, completely
stopping before going into the reverse position.
NOTE:
Always
STOP
completely, before changing directions.
NEVER
operate the
machine in reverse, with Rear Assembly in the
DOWN
position.
Summary of Contents for SP 300
Page 1: ......
Page 27: ...25 HYDRAULIC FLOW CHART ...
Page 41: ...39 SQUEEGEE SP300 DUAL SPRAY SANDPUMPER II SANDPUMPER II ...
