SealMaster CRACK PRO 125, Owner'S Manual

Page: 13 / 74

13
CRACK PRO® HEATED HOSE MACHINE
PRE-OPERATION INSTRUCTIONS
CHECK LIST
THE ENTIRE UNIT SHOULD BE CHECKED
Even though your Crack Pro joint sealing machine is ready for
operation when you receive it, certain items should be checked before
putting it to use.
If you have any questions on the operation of this machine discontinue
operation of the machine and call the factory immediately.
(419-626-4375)
Most important items to check are listed below:

Check nuts, set screws, and bolts to assure that no loosening
occurred doing shipment.

Check tightness of all heat transfer oil HTO hoses. (steel braided
hoses)

Check to be sure the HTO vent pipe is clear and open for venting,
located on the HTO expansion tank.

Check wheel lug nuts after first 100 miles of travel.

Never operate machine unattended.

Never exceed heat transfer oil limit of 500°F when operating.

Do not expose material hose to direct flame.

Close tank lid before transporting.