SAFETY GUARD FOR PRESSES
MODEL NO’S:
YKGS20, 30, 50, 75
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
9
Regularly check guard for worn, loose, or damaged parts. If you find any of these conditions
DO NOT
USE THE GUARD.
Failure to do so may cause severe injury!
9
Keep the guard free of dirt and debris.
8
DO NOT
add to or modify any part of the guard. Doing so will void your warranty.
8
DO NOT
use the guard for purposes other than those it was designed for.
9
Clean guard with water and mild detergent.
9
Always refer to the safety instructions provided in your floor press instruction manual.
WARNING!
The warnings, cautions and instructions referred to in this manual cannot cover all possible conditions and situations that
may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be
applied by the operator.
2. INTRODUCTION
L
ightweight aluminium frame with tough steel mesh. Adjustable guard protects the user and/or passer by from being injured if workpiece is
accidently dislodged under load. Bolts onto either side of the table and features five height increments, allowing the workpiece to be placed onto
table with no obstruction. One-way spring loaded locking clips then allow the guard to be pulled up quickly and snap straight into position for full
protection.
3. SPECIFICATION
Model No: ................................................................ YKSG20
A
pplications:
............................................ YK209F, YK20FFP
Model No: ................................................................ YKSG30
A
pplications:
.............................YK30F, YK30FAH, YK30FFP
Model No: ................................................................ YKSG50
A
pplications:
.........................YK509F, YK509FAH, YK50FFP
Model No: ................................................................ YKGS75
A
pplications:
.......................................... YK759F, YK759FAH
4. ASSEMBLY/ OPERATION
4.1.
Choose which side of the floor press to fit the guard, fix the guard support brackets to the
table using the pre-drilled holes and fixings provided. See figs.1&2.
Ensure the brackets are fitted with the locks on the outside and the correct way up as fig.1.
Refer to
instruction
manual
Y
KSG20, 30, 50, 75 Issue:2 (H,F) 07/04/22
Original Language Version
© Jack Sealey Limited
Guard Support
Guard Support
Bracket Fixings
Bracket Fixings
Ensure The Correct
Ensure The Correct
Orientation Of The
Orientation Of The
Locking Mechanism
Locking Mechanism
Rear
Rear
View Of
View Of
Bracket
Bracket
Fixings
Fixings
fig.1
fig.2
