cROSS BEAM ADAPTOR 2TONNE
MODEL NO:
X136
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
9
Ensure that the cross beam adaptor is in good working order. Take action for immediate repair or replacement of damaged parts.
Use
genuine parts only. The use of unauthorised parts may be dangerous and will invalidate the warranty.
9
Keep work area clean and tidy and free from unrelated materials.
9
Ensure the vehicle handbrake is engaged, engine/motor is switched off and transmission is in 1st or reverse gear.
9
Ensure minimum distance of 0.5m between vehicle and static objects such as doors, walls, etc., to allow for vehicle tilting.
9
Only place the cross beam adaptor under those lifting points recommended by the vehicle manufacturer
(see vehicle handbook).
9
Ensure there are no passengers in the vehicle.
9
Ensure all non-essential persons keep a safe distance whilst the the cross beam adaptor is in use.
▲
DANGER: Use the
the cross beam adaptor
for lifting only,
NOT for supporting the lifted load.
9
Use suitable capacity axle stands under the vehicle before proceeding with any task.
9
Ensure there are no persons or obstructions beneath the vehicle before lowering.
8
DO NOT
allow untrained persons to operate the cross beam adaptor.
8
DO NOT
exceed the rated capacity of the cross beam adaptor.
8
DO NOT
work under the vehicle until axle stands have been correctly positioned.
8
DO NOT
use the cross beam adaptor for purposes other than that for which it is designed.
8
DO NOT
jack vehicle if there is a risk of spillage of fuel, battery acid, or other dangerous substance.
9
When not in use store the cross beam adaptor in a safe, dry, childproof area.
WARNING!
It is
very dangerous to go under a vehicle which is supported by a jack even if additional supports are used. DO NOT go under a
vehicle unless it is supported by adequately rated axle stands.
2. INTRODucTION
Provides extra safety when locating awkward jacking points. Ideal for front wheel drive vehicles. Suitable for jacks with 31-33mm saddle spigot
pin.
3. SPEcIFIcATION
Model no ........................................................................X136
Applications ........... 3000CXD, 3003CXQ, 3010CX, 3012CXD
Max. width .................................................................. 820mm
Min. width ................................................................... 580mm
Weight ....................................................................... 12.90kg
Screw adjustment ......................................................... 75mm
4. cONTENTS
Refer to
instruction
manual
Wear safety
footwear
X136 | Issue:2 (H,F) 03/09/18
Original Language Version
© Jack Sealey Limited
1 Adaptor
2 Expansion beam
3 Chain
4 Bolt
5 Fixed beam
6 Washer
7 Bolt
fig.1
