1. Safety Precautions and Warnings
•
WARNING! Ensure that Health and Safety, local authority and
general workshop practice regulations are strictly adhered to.
•
DO NOT use the unit if it, or any attachment, is damaged.
•
Maintain the unit in good and clean condition for best and safest
performance.
•
If required, ensure that the vehicle to be worked on is adequately
supported with axle stands or ramps and is chocked.
•
Put transmission in PARK (for automatic transmission) or
NEUTRAL (for manual transmission) and make sure the parking
brake is engaged.
•
Wear approved eye protection. A full range of personal safety
equipment is available from your Sealey dealer.
•
3Wear suitable clothing to avoid snagging. Do not wear jewellery
and tie back long hair.
•
WARNING! Use extreme caution when working around the
ignition coil, distributor cap, ignition wires and spark plugs. These
components create hazardous voltages when the engine is running.
•
DO NOT connect or disconnect any test equipment with ignition
on or engine running.
•
Keep a fire extinguisher suitable for gasoline/chemical/ electrical
fires nearby.
•
Account for all tools and parts being used and do not leave them
on or near the engine.
•
Keep code reader dry, clean and free from oil, water and grease.
Use a mild detergent on a clean cloth to clean the outside of the
tool.
•
Operate the vehicle in a well-ventilated work area; exhaust gases
are poisonous.
IMPORTANT: Always refer to the vehicle manufacturer’s service
instructions to establish the current procedure and data. These instructions are
provided as a guide
only.
< V2.6 USB-V1.9 SERIAL SOFTWARE
V
2
< V2.6 USB-V1.9 SERIAL SOFTWARE
2
