7) Use
the
UP/DOWN
scroll buttons to select the system from the
Select System
menu and press the
Y
button.
Main Menu
►
1) VW/AUDI
2) OBDII/EOBD
3) Oil Service
4) System Setup
Select System
►
01) Engine
02) Auto Trans
15) Airbags
03) ABS Brakes
08) Auto HVAC
09) Cent. Elect.
If the scan tool fails to communicate with the selected
vehicle’s ECU (Electronic Control Unit), a “LINK
ERROR!” message shows up on the display.
Verify that the ignition is ON;
Check if the scan tool’s OBD II connector is securely
connected to the vehicle’s DLC;
Verify that the module is supported;
Turn the ignition off and wait for about 10 seconds. Turn the
ignition back to on and repeat the procedure from step 5.
If the “LINK ERROR” message does not go away, then
there might be problems for the scan tool to communicate
with the module being tested. The most common cause is
that the scanned module is not supported on the vehicle.
The numbers (01, 02, 15, 03, 08, etc) in front of the system
names refer to the physical addresses assigned to the systems,
not the sequence of the systems to be arranged.
< V2.6 USB-V1.9 SERIAL SOFTWARE
V
11
< V2.6 USB-V1.9 SERIAL SOFTWARE
11
