bUSH INSTALLATION/REMOVAL KIT - VAUXHALL
mODEL NO:
VS721.V2
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
1. SAFETY
WARNING!
Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this tool.
WARNING!
Familiarise yourself with the specific applications and limitations of this tool, as well as any potential hazards.
9
This tool should be used in conjunction with inspection maintenance procedures recommended in the vehicle manufacturer’s manual.
9
Ensure that this tool is the correct tool for the task.
9
Ensure that the vehicle is properly supported with axle stands before working under the vehicle.
9
Ensure that there is adequate lighting prior to using this tool.
9
A range of inspection lamps are available from your local Sealey stockist.
9
Keep children and unauthorised persons away from the working area.
9
Keep the threaded rod well lubricated during operation to ease removal of bushes.
8
DO NOT
use this tool
for any purpose other than that for which it is designed.
8
DO NOT
use air tools with this tool.
8
DO NOT
use this tool if any parts are missing or damaged, as this may cause failure and/or personal injury.
8
DO NOT
use this tool
when you are tired, or under the influence of alcohol, drugs or intoxicating medication.
9
When not in use, store in a safe, dry location.
2. INTRODUcTION
Intended for the in-situ removal/installation of Vauxhall/Opel Vectra (95 -02) upper and lower rear trailing arm bushes. Bushes are quickly
pressed in or out with tool and a 19mm ratchet wrench (not included).
3. cONTENTS
Refer to
instruction
manual
Wear eye
protection
Original Language Version
© Jack Sealey Limited
Item
Part no.
Description
A
VS721.V2-02
pressed support sleeve 55.5 x 54mm
B
VS721.V2-01
pressed support sleeve 24.5 x 45mm
C
VS721.V2-03
pressed support sleeve 20 x 45mm
D & F
VS721.V2-06
Screw nut
E
VS721.02-08
Thick spacer
G
VS721.02-04
Threaded rod
ALWAYS KEEP THREADED ROD
WELL LUbRIcATED.
x
DO NOT USE AIR TOOLS.
Threaded rod maximum load 150Nm. Exceeding this load will
shorten the life of the threaded rod. The threaded rod is
considered to be a consumable item and is NOT covered under
warranty.
VS721.V2 | Issue:3 (H,F) 12/02/19
