© Jack Sealey Limited
Original Language Version
INSTRUCTIONS FOR:
ADJUSTABLE PRESS
SUPPORT PLATE
MODEL NO:
VS7037
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions
and maintained properly, give you years of trouble free performance.
Refer to Instruction
Manual
Wear Eye
Protection
1. SAFETY
WARNING!
Ensure Health and Safety, local authority and general workshop practice regulations are adhered to when using tools.
DO NOT
use the kit if any parts are missing or damaged.
DO NOT
use this tool for any purpose other than that for which it is designed.
Maintain the tool components in good and clean condition for best and safest performance.
Wear approved eye protection. A full range of personal safety equipment is available from your Sealey dealer.
Wear suitable clothing to avoid snagging. Do not wear jewellery and tie back long hair.
DO NOT
use when tired or under the influence of drugs, alcohol or intoxicating medication.
Keep children and other unauthorised persons away from the working area.
Ensure there is adequate lighting prior to using this tool.
2. INTRODUCTION
Designed to be used with a standard workshop press. Adjustable diameter and six interchangeable support legs provides quick alignment of hub
or suspension frame for secure and level pressing. Ideal when removing and installing wheel bearings and bushes.
3. SPECIFICATION
4. OPERATION
Model No . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . VS7037
Operating Diameter: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 78-100mm
fig.1
fig.2
4.1.
The support plate is supplied with 2 sets of supports (figs 1 & 2) . If required, these supports may be mixed in use.
4.2.
The supports can be changed by sliding onto the carriers and fixing by means of the setscrew.
4.3.
Once fitted, the supports can be adjusted radially by turning the lower section whilst holding the upper (fig.1).
4.4.
One of the smaller supports
i
ncorporates a screw adjustment to allow exact levelling of the workpiece.
4.5.
Support the workpiece to allow free exit for the component to be pressed out (fig.3).
VS7037 Issue: 1 - 03/06/16
