OIL FILTER DRAIN TUBE - OIL FILTER DRAIN
TUBE & BOTTLE
Model no:
VS7010 & VS7110
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETy
9
Keep the drain tube and bottle clean and maintain it in good condition.
9
Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Keep all non-essential persons away from the work area.
9
Check connections and fittings before use.
9
ensure that the bottle capacity exceeds the amount of fluid to be collected.
8
DO NOT
use for any purpose other than that for which it is designed.
8
DO NOT
operate if any parts are damaged or missing as this may cause failure and/or personal injury.
8
DO NOT
leave drain tube and bottle operating unattended.
IMpORTANT!
ensure that you wear protective clothing, gloves, goggles, face mask as appropriate for the fluid being extracted.
WARNING! DO NOT
allow uncontrolled discharge of fluids thus polluting the environment.
9
dispose of waste fluids in accordance with local authority regulations.
WARNING!
DO NOT
use with gasoline or other flammable liquids.
8
DO NOT
use the unit to extract dangerous chemicals, poisons, acids, alkaline or solvents.
9
The container is not designed for long term storage.
8
DO NOT
store the unit under extreme conditions.
8
DO NOT
adapt the unit for any other purpose.
9
When not in use, store in a safe, dry, childproof area.
2. INTRODUcTION
Model No. VS7010 Designed to attach to the oil filter housing on VAG FSi petrol engines. Allows the filter housing to be drained
before removal, preventing spillage. Use in conjunction with a suitable oil drainer. Model No. VS7110 Features a control valve fitted
to the bottle and hanging chain.
3. OpERATION
3.1.
With the vehicle on a suitable ramp drain engine oil.
3.2.
Locate the oil filter (black plastic housing).
3.3.
Remove the dust cover on the bottom of the housing to expose the red bleed valve.
3.4.
VS7110
- Secure drain bottle using the retaining chain and open valve, on top of the drain bottle.
3.5.
Screw the adaptor into the end of the plastic housing. Screwing in the adaptor will release the red bleed valve in the filter housing
which allows the oil to drain.
3.6.
once fully drained unscrew adaptor.
3.7.
The filter housing can now be removed from the engine using the large hex located at the bottom of the filter housing.
4. MAINTENANcE
Keep the unit clean, wipe off any fluid spillage. Keep the tubes clean and clear of blockages. Check that all tubes and connections are
in good condition.
V
S7010 VS7110 Issue 2 (HF) 24/08/18
Original Language Version
© Jack Sealey limited
Refer to
instructions
VS7010
Wear eye
protection
Wear protective
gloves
Wear a mask
VS7110
