nUT/BOLT DRILL JIG
mODEL NO:
VS559
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
9
Store the tool in a safe childproof place when not in use.
9
Use in a suitable, clean and tidy work area, free from unrelated materials. Ensure there is adequate lighting.
8
DO nOT
allow untrained people to use the tool.
8
DO nOT
allow children to use or play with the tool.
8
DO nOT
use the tool for tasks it is not designed to perform.
8
8
88
DO nOT
operate tool if any parts are damaged or missing as this may cause failure and/or personal injury.
8
DO nOT
operate the tool when you are tired or under the influence of alcohol, drugs or intoxicating medication.
2. InTRODUcTIOn
An essential race-day tool. Compact design ensures accurate drilling of nuts and bolts. Supplied in a pouch.
3. SpEcIFIcATIOn
model no ..................................................................... VS559
Sizes:
m6 x 1, m8 x 1, m8 x 1.25, m10 x 1.25, m10 x 1.5, m12 x 1.5mm
4. OpERATIOn
8
DO nOT hand-hold
; Always mount in a vice or clamp to pillar drill table.
4.1.
Screw bolt into bolt jig until shank is past the cross shaft.(See Fig.1)
4.2.
Apply a 1.5mm drill to the smaller end of the cross shaft and drill through the bolt.
4.3.
Similarly, clamp nut into nut jig (see Fig.2) and drill through the jig from the smaller end of the cross shaft using a 1.5mm drill. This will
pierce the corner of the nut allowing a safety wire to be inserted.
Refer to
instruction
manual
Original Language Version
© Jack Sealey Limited
fig.1
fig.2
VS559| Issue:2 (H,F) 25/06/19
