INSTRUCTIONS FOR:
BOSCH / DELPHI
DIESEL INJECTOR PULLER
MODEL NO:
VS2049
WARNING!
Ensure Health and Safety, local authority and general
workshop practice regulations are adhered to when using tools.
DO NOT
use the kit if any parts are missing or damaged.
DO NOT
use this tool for any purpose other than that for which
it is designed.
Switch off vehicle ignition and disconnect the battery before
working under the bonnet.
When work on the vehicle is finished ensure that there are no
tools left under the bonnet.
Maintain the tool components in good and clean condition for
best and safest performance.
Wear approved eye protection. A full range of personal safety
equipment is available from your Sealey dealer.
Wear suitable clothing to avoid snagging. Do not wear jewellery
and tie back long hair.
Keep children and other unauthorised persons away from the
working area.
Ensure there is adequate lighting prior to using this tool.
IMPORTANT:
Always refer to the vehicle manufacturer's service
instructions, or proprietary manual, to establish the current
procedures and data.
Item Part No:
Description
1
VS2049.01
Sliding hammer
2
VS2049.02
Handle (Length 73mm)
3
VS2049.03
Spindle Length 220mm)
4
VS2049.04
Ball type adaptor
VS2049.04-1
Hex nut
VS2049.04-2
Hex nut (male type)
5
VS2049.05
Adaptor (M17, Injector internal thread)
6
VS2049.06
Adaptor (M27,Injector external thread)
7
VS2049.07
Hex key M10 + M19
8
VS2049.08
M29 Socket with cut out (1/2" drive)
Suitable for the removal of stubborn Bosch/Delphi diesel injectors. Set
includes two adaptors for different removal methods. The first screws
onto the injector cap and the second locates internally inside the injector
allowing for extra force to be used. Features a flexible joint allowing the
slide hammer to be used in restricted areas. Supplied with instructions
in carry-case.
Contents:
1.8kg Slide Hammer, Flexible Joint, 2 x Adaptors, Security
Hex Key 10mm, Injector Cap Socket.
Adaptor Thread Sizes:
Ø17mm Male x 1mm Pitch, Ø28mm Female x 1mm Pitch.
5.1.
Referring to the individual components in fig.1 assemble the
Injector Puller as shown above in fig.2.
5.2.
Use adaptor 6 when the injector is being extracted using the
external thread revealed when the injector cap has been
removed.
5.3.
Use adaptor 7 when the injector is being extracted using the
internal thread revealed when the inner sleeve has been
removed from the injector.
fig.2
fig.1
1. SAFETY
2. INTRODUCTION
4. CONTENTS
5. ASSEMBLY
3. SPECIFICATION
VS2049 Issue: 2(L) - 20/03/15
Original Language Version
© Jack Sealey Limited
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
