![background image](http://html.mh-extra.com/html/sealey/vs0208/vs0208_instructions_1226780001.webp)
instructions for
bRAKE FLUID bLEEDER 12V
model no:
Vs0208
Thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. sAFETY
1.1.
PERsONAL PRECAUTIONs
9
Wear safety eye protection and protective clothing. Avoid touching eyes while working near battery. Wash immediately with soap and
water if battery acid contacts skin or clothing. If acid enters eye, flush eye immediately with cool, clean running water for at least 15
minutes and seek immediate medical attention.
9
remove personal metallic items such as rings, bracelets, necklaces and watches. A lead-acid battery can produce a short-circuit
current which is high enough to weld such items to the vehicle and cause severe burns.
8
DO NOT
smoke or allow a spark or flame in the vicinity of the battery or engine.
WARNING!
to prevent the risk of sparking, short circuit and possible explosion
DO NOT
drop metal tools in the battery area, or allow
them to touch the battery terminals.
8
DO NOT
cross-connect unit to battery. ensure positive (red) clamp is to positive terminal and negative (BlAcK) clamp is to negative
terminal.
WARNING!
Brake fluid is hazardous, wear approved eye protection and keep skin contact to a minimum. If brake fluid enters eyes,
rinse immediately with plenty of water and seek medical advice. if swallowed seek medical advice immediately.
WARNING!
Brake fluid is flammable - keep away from sources of ignition, including hot surfaces e.g. exhaust manifold.
WARNING!
Brake fluid will damage paintwork and clothing. Any spillages should be flushed with water immediately.
1.2.
GENERAL sAFETY.
WARNING!
ensure Health and safety, local authority and general workshop practice regulations are adhered to when using this unit.
IMPORTANT:
if possible, refer to the vehicle manufacturer’s service instructions to establish the correct procedure.
9
maintain this product in good working order and condition, take immediate action to repair or replace damaged parts.
9
use approved parts only. unapproved parts may be dangerous and will invalidate the warranty.
WARNING!
only use new brake fluid, used brake fluid or other fluids will contaminate the system and possible brake system failure
may result.
8
DO NOT
use to perform a task for which it is not designed.
8
DO NOT
allow untrained persons to use the unit.
8
DO NOT
use when tired or under the influence of drugs, alcohol or intoxicating medication.
WARNING! DO NOT
pollute the environment by allowing uncontrolled discharge of fluids.
9
Keep children and unauthorised persons away from the work area.
9
Keep work area clean and tidy and free from unrelated materials.
9
ensure the work area has adequate lighting.
9
ensure that a vehicle which has been jacked up and had its wheels removed, is adequately supported with axle stands.
WARNING! DO NOT
use with Mineral Fluids unless the machine is manufactured specifically for and dedicated to that purpose.
9
Mineral and conventional fluids do not mix. Cross contamination, however small, between mineral and DOT 3/4/4.1/5 fluids will always
result in brake failure.
8
DO NOT
disconnect universal adaptor from brake fluid reservoir until the unit has been de-pressurised.
9
Dispose of waste brake fluid in accordance with local authority regulations.
9
Always read and comply with the warnings on the brake fluid container.
9
Wear suitable clothing to avoid snagging.
DO NOT
wear jewellery, and tie back long hair. A full range of personal safety equipment is
available from your sealey stockist.
9
When not in use, clean unit and store in a safe, dry, childproof location.
2. INTRODUCTION
Bleeds brakes first time, every time (one-man bleeding operation). Powered by the vehicle’s 12V battery and maintains system pressure using
an electric pump to drive clean brake fluid through a long high pressure hose to the reservoir. Variable pressure delivery means that vehicles with
specific requirements may be bled safely. Pressure can be adjusted to a maximum pressure of 2bar which is suitable for most vehicles. supplied
with a Ø45mm semi-universal reservoir cap which will fit a large percentage of European manufactured vehicles from 1997 onwards.
V
S0208 | Issue: 3 (2,3) 12/10/18
Original Language Version
© Jack sealey limited
refer to
instruction
manual
Wear eye
protection