Refer to
instructions
Electrical
shock
hazard
Hot surfaces
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
LP170 Issue: 3 (1) 02/07/18
Original Language Version
© Jack Sealey Limited
Space warMer® propane heaTer 102,000-
170,000BTu/hr
ModEL no:
Lp170
1. SafeTy
1.1. electrical Safety
warnInG!
It is the user’s responsibility to check the following:
Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and
all electrical connections for wear and damage. Sealey recommend that an RCd (Residual Current device) is used with all electrical
products. You may obtain an RCd by contacting your local Sealey dealer.
If used in the course of business duties, it must be maintained in a safe condition and routinely PAT (Portable Appliance Test) tested.
It is important that the following information is read and understood.
9
Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
9
regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
9
Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the correct fuse - see
fuse rating in these instructions.
8
Do noT
pull or carry the appliance by the power cable.
8
Do noT
pull the plug from the socket by the cable.
8
Do noT
use worn or damaged cables, plugs or connectors. Ensure that any faulty item is repaired or
replaced immediately by a qualified electrician.
9
This product is fitted with a BS1363/A 13 Amp 3 pin plug.
If the cable or plug is damaged during use, switch the electricity supply and remove from use.
Ensure that repairs are carried out by a qualified electrician.
Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a qualified electrician.
a) Connect the GREEn/YELLoW earth wire to the earth terminal ‘E’.
b) Connect the BROWN live wire to the live terminal ‘L’.
c) Connect the BLUE neutral wire to the neutral terminal ‘N’.
Ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.
Sealey recommend that repairs are carried out by a qualified electrician.
1.2.
General Safety
warnInG!
disconnect heater from mains electrical supply and gas cylinder before servicing or performing
maintenance. Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the
warranty.
warnInG! noT
to be used for the heating of habitable areas of domestic premises: for use in public buildings, refer to national
regulations.
warnInG! Do noT
use in basements or areas below ground level.
9
Store gas cylinders in accordance with regulations applicable to such appliances.
9
Ensure that nothing stands or passes in front of the heater. Minimum distance from the heater is 2 metres at the front, sides and rear
0.65m and 0.95m above
9
only use the propane gas pressure regulator and hose assembly supplied with the heater, without alteration.
9
only use outdoors or in well ventilated surroundings in a well ventilated area away from combustible materials.
9
Ensure continuous ventilation is provided to the heater operating area. A ventilation opening must run to the outside of the premises
where the heater is to be operated. The opening must be 100cm² for every kW and must also be set at an equal distance from the
upper and lower parts of the heater operating area.
warnInG!
If the heater is used for prolonged periods at maximum power, ice may form on the propane cylinder. This is due to
excessive evaporation. In such a case
Do noT
use the heater to de-ice the cylinder.
warnInG!
If the smell of gas is present, isolate the gas cylinder immediately and investigate reason before re-connecting it.
8
Do noT
use the heater if damaged. Take immediate action to repair or replace damaged parts. Use an authorised service agent only.
8
Do noT
use the heater for residential use or in recreational vehicles.
8
Do noT
allow untrained persons to ignite the heater.
8
Do noT
operate the heater without the cover.
8
Do noT
use a naked flame to try and ignite the heater.
8
Do noT
use the heater near flammable or explosive materials - liquids, solids or gases.
8
Do noT
cover the heater whilst in use.
8
Do noT
leave the heater unattended whilst in use.
8
Do noT
obstruct the air inlet and outlet sections of the heater. Keep immediate area clean and tidy.
8
Do noT
point the heater towards the gas cylinder.
9
Keep children and vulnerable people away from the heater.
Recommended fuse rating
13 Amp
Warning:
explosive
material
do not cover
This product is not suitable for primary heating purposes
