floor stand for sm27.v2
model no:
sm27st.v2
thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. safEtY
WarnInG!
The lathe (not included) is heavy - it is recommended that two persons lift and lower the lathe onto the assembled stand.
9
Avoid trapping hands/fingers beneath the lathe, when lowering onto the stand.
9
Ensure the stand is positioned on firm, level ground (we recommend concrete or a similar hard surface).
9
Ensure the surrounding environment is not conducive to rust. Rust will damage the stand, rendering it structurally unsafe.
2. IntroductIon
Suitable for model no. Sm27 metal turning lathe an other similar lathes. Includes suds tray.
3. spEcIfIcatIon
model no ............................................................. Sm27ST.V2
Weight ............................................................................ 50kg
4. contEnts
5.
a
assEmblY
note: Assemble with fixings left loose in order to align parts
then tighten before use.
5.1.
Attach the three hole side of the angle brackets (4) to the
cabinets (2 & 3) using M5x12 screws (9), Ø5 flat washers (10),
5.2.
Ø5 spring washers (11) and the M5 hex nuts (12).
5.3.
Attach the kick plate (5) to the two hole side of the angle
brackets (4) using M5x12 screws (9), Ø5 flat washers (10), Ø5 spring washers (11) and the M5 hex nuts (12), joining the cabinets (2 &
3) together.
5.4.
Place the suds tray (1) on top of the cabinets (2 & 3) and align the screw holes.
5.5.
Align the l/H and R/H shim blocks (6 & 7) over the screw holes in the suds tray (1) and the cabinets (2 & 3). Secure into place using
the m6x25 screws (8).
Refer to
instruction
manual
Wear
protective
gloves
S
M27ST.V2 | Issue:3 (H,F) 06/06/18
Original Language Version
© Jack Sealey limited
ItEm
dEscrIptIon
QtY
1
SUdS TRAY
1
2
R/H CABIneT
1
3
l/H CABIneT
1
4
AnGle BRACKeT
2
5
KICK PlATe
1
6
R/H SHIm BloCK 150mm
2
7
l/H SHIm BloCK 200mm
2
8
SCReW m6x25
8
9
SCReW m5x12
10
10
Ø5 FLAT WASHER
10
11
Ø5 SPRING WASHER
10
12
m5 HeX nUT
10
13
BolT m10x100
4
14
Ø10 FLAT WASHER
4
15
Ø10 SPRING WASHER
4
16
m10 HeX nUT
4
fig.1