6.2.2.
Remove the water collection tank and empty the water out of it. Remove the tank cover and wash the inside of the tank with clean
water. The tank may be scratched if it is scrubbed strongly with a brush.
DO NOT
remove the float lever from the tank. Wipe off the
water on the outside of the tank with a cloth. Refit the tank cover onto the tank and replace the tank in position.
6.2.3.
Clean the air filter (see 6.1).
6.2.4.
When the unit is to be stored for a long time, wipe the dehumidifier over with a dry soft cloth. To remove dirt, wipe over with a very
slightly dampened cloth (never use a wet cloth for cleaning the controls). To avoid deformation or cracking, do not use benzine,
thinner or liquid cleaners.
6.2.5.
When storing, place in a safe, dry, childproof location. Stand the unit upright and avoid exposure to direct sunlight.
7. TROUBLE SHOOTING
7.1.
Upon fault of the dehumidifier, please cut off the power supply immediately, unplug the plug and check the following items:
7.2.
If the said methods still fail to eliminate the above problems, please directly contact the manufacturer or agents.
DO NOT
disassemble
the dehumidifier, contact Sealey for repairs.
F
aults
Cause Analysis
Solutions
F
ails to turn on
Shown as no power
No power to the wall socket.
Check the power supply.
Check the plug plugged in
properly.
Plug the power supply in the socket.
Check the fuse is not blown.
Replace the fuse.
Power Transformer is broken.
Replace the transformer.
Shown as power on
Environmental humidity lower
than the set value.
Set again according to the demand.
If the water tank is installed
correctly.
Place the water tank in right position.
If the entire machine is defrosting. Wait for the completion of defrosting cycle.
Unfavourable
dehumidifying effect
If the air inlet/outlet is obstructed.
Remove the obstacle.
If the door and window are open.
Close the door and window.
If the indoor temperature is too low.
D
on’t run the dehumidifier.
Heavy noise
I
f the ground is firm and flat.
R
esettle the dehumidifier.
D
ehumidifier is stood precariously.
R
esettle the dehumidifier.
Water leakage
D
ehumidifier stood on an incline.
M
ove dehumidifier to a level surface.
Drain pipe/outlet obstructed.
Dismantle the front plate to eliminate blockages.
E1
Coil sensor fault
Turn to timing for defrosting, to cancel system fault
function.
E2/E3
F
ault of humidity & temperature sensor.
Replace the humidity & temperature sensor.
EE
Refrigerant leakage.
Start the machine after. Ask for help from
professionals if the “EE” signal remains.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
01284 703534
www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important
: No Liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
S
DH50110V Issue 2 12/07/2021
Original Language Version
© Jack Sealey Limited
