background image

ULTRASONIC PARTS CLEANING TANKS

3L / 9L / 27L.

MODEL NO’S:

 SCT03.V2, SCT09.V2, SCT27.V2

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these 
instructions, and properly maintained, give you years of trouble free performance.

IMPORTANT:

 PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE 

THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR 

PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

1.  SAFETY

1.1. 

  

ELECTRICAL SAFETY

 

‰

  

WARNING!

 It is the user’s responsibility to check the following:

 

Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and    

 

all electrical connections for wear and damage. Sealey recommend that an RCD (Residual Current Device) is used with all electrical  

 

products. You may obtain an RCD by contacting your local Sealey Stockist. 

 

If the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAT (Portable  

 

 

Appliance Test) tested.

 

Electrical safety information, it is important that the following information is read and understood.

1.1.1.   

Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply. 

1.1.2.   

Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.

1.1.3. 

  

Important

: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is

 fitted with the    

 

correct fuse - see fuse rating in these instructions.

 

8

  

DO  NOT

 pull or carry the appliance by the power cable.

 

8

  

DO NOT

 pull the plug from the socket by the cable. 

 

8

  

DO  NOT

 use worn or damaged cables, plugs or connectors. Ensure that any faulty item is repaired or is 

  replaced immediately by a qualified electrician.

1.1.4. 

  

This product is fitted with a BS1363/A 13 Amp 3 pin plug. 

        

If the cable or plug is damaged during use, switch the electricity supply and remove from use. 

        

Ensure that repairs are carried out by a qualified electrician.

        

Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a qualified electrician.

 

a) Connect the GREEN/YELLOW earth wire to the earth terminal ‘E’.

 

b) Connect the BROWN live wire to the live terminal ‘L’.

 

c) Connect the BLUE neutral wire to the neutral terminal ‘N’.

       

Ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight. 

        

Sealey recommend that repairs are carried out by a qualified electrician.

1.2.    

GENERAL  SAFETY

 

8

  

DO NOT

 run the cleaner continuously for more than one hour at a time, as doing so can damage the internal components.

 

8

  

DO NOT

 operate the unit without fluid in the tank. Always ensure the fluid is no higher than 2/3rd full. Always ensure there is a    

 

minimum depth of 7cm.

 

8

  

DO NOT

 drop any item into the tank as this may cause damage to the transducer. Always place the items gently into the tank and  

 

use the basket whenever possible.

 

9

   The more items that you place in your cleaning bath the less efficiently it will clean. It is not advised to overlap items. Always allow  

 

plenty of clear space between the items.

 

9

   Keep the lid on during use. This will prevent splashes and reduce evaporation of the fluid.

 

8

  

Never immerse the machine or power cord in water or other liquid.

 

8

  

DO NOT

 touch the power plug with wet hands, especially when inserting or removing the plug.

 

8

  

DO NOT

 touch the unit if the machine has fallen into water during operation. Remove the power plug from the socket first.

 

8

  

DO NOT

 disassemble the machine, except by professionals.

 

9

  

UNPLUG

 the power source while filling or emptying the tank.

 

8

  

DO NOT

 spray water or liquid over the device and the control panel.

 

8

  

DO NOT

 operate the cleaner without proper grounding.

 

8

  

DO NOT

 place the device on a soft surface, where the vents could be blocked.

 

9

   Upon completion of the cleaning cycle, turn the heater off and isolate the machine from the electrical supply.

 

9

   Take care when adding or removing items from the cleaning tank as the fluid is likely to be hot and displaced fluid can damage the  

  internal components. Any displaced fluid must be dried up immediately.

 

9

  

This device is not intended to use by individuals with restricted physical sensory or metal capacities or those with lack of experience  

 

or knowledge, include children, unless they are supervised by an individual who is responsible for their safety or have received    

 

training in operating the device.

 

9

  

Keep it away from children!

Recommended fuse rating

13 Amp

S

CT27.V2, SCT09.V2, SCT03.V2  Issue 2 (2) 07/04/22

Original Language Version

© Jack Sealey Limited

Refer to 

instructions

Electrical shock 

hazard

Hot surfaces

 

Wear eye 

protection

 

Wear protective 

gloves

Summary of Contents for SCT03.V2

Page 1: ...OW earth wire to the earth terminal E b Connect the BROWN live wire to the live terminal L c Connect the BLUE neutral wire to the neutral terminal N Ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight Sealey recommend that repairs are carried out by a qualified electrician 1 2 GENERAL SAFETY 8 DO NOT run the cleaner continuously for more than one h...

Page 2: ...EGENERATION For cleaning dot matrix printers and photocopier ink cartridges 4 5 MAINTENANCE Bicycle gears air purifiers It cleans out debris in tiny holes and crevices effectively 5 PREPARATION 5 1 Carefully unpack the cleaner and remove all traces of packing materials from it Visually inspect the cleaner for any parts that may have become loose or damaged during transit 5 2 Place the cleaner on a...

Page 3: ...Warm water and dish washing liquid can soften grease and improve cleaning results Heating range is from 5o C to 80o C 6 3 3 When setting the temperature if you want the temperature of the bath to be higher than the current temperature press Heat button The heating will come on If the required temperature is below the ambient temperature the heating will not come on Heating does shut off automatica...

Page 4: ...lid waste authority for recycling information ENVIRONMENT PROTECTION Recycle unwanted materials instead of disposing of them as waste All tools accessories and packaging should be sorted taken to a recycling centre and disposed of in a manner which is compatible with the environment When the product becomes completely unserviceable and requires disposal drain any fluids if applicable into approved...

Reviews: