MECHANIC’S DETAILING UTILITY SEAT
MODEL NO:
SCR90
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING!
Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this seat.
9
Locate seat in a suitable working area.
WARNING!
Use seat on level and solid ground, preferably concrete.
9
Keep the seat clean and tidy in accordance with good workshop practice.
8
DO NOT
use the seat
for any purpose other than that for which it is designed.
8
DO NOT
stand on the seat.
8
DO NOT
use the seat outdoors.
8
DO NOT
get the seat wet or use in damp or wet locations or areas where there is condensation.
8
DO NOT
clean the seat with any solvents which may damage the paint surface or the protective coating on the padded seat base.
8
DO NOT
use if damaged.
2. INTRODUCTION
Extra thick cushioned padding for added comfort when seated. Suitable for use in Bodyshop and Detailing environments as well as general
garage use. Easy-rolling Ø100mm rubber castors with ball-bearing swivel. Cup/bottle holders and storage trays for tools and components.
3. SPECIFICATION
Model No ....................................................................SCR90
Overall Size (W x D x H) .........................680 x 460 x 410mm
4. CONTENTS
1 Seat
2 Frame
3,4,6,7 Trays
5 Nuts
8 Wheels
5. ASSEMBLY
5.1.
Place castors through frame (2) and secure with nut
and washer (5).
5.2.
Fit tray (7) into base of frame (2).
5.3.
Fit trays (3 & 4).
5.4.
Slide tray (6) under seat.
6. MAINTENANCE
6.1.
Before each use, inspect the overall condition of the
unit for broken, cracked or bent parts that may
affect the proper operation.
6.2.
Regularly check the tightness of all fixings before use.
6.3.
Smear the castor bearings with a thin film of silicone
grease quartlerly.
6.4.
Ensure the castor wheels are able to rotate and swivel freely. Replace if necessary.
6.5.
Clean the seat cushion, trays and frames with a moist cloth and mild detergent.
DO NOT
use solvents to clean the unit.
Refer to
instructions
SCR90 Issue 1 19/04/22
Original Language Version
© Jack Sealey Limited
