CREEPER WITH ADJUSTABLE HEADREST
MODEL NO:
SCR74.V3
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
I
MP
PO
R
RTA
TANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
TH
HE
P
PR
O
ODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PE
ER
S
SON
NAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING!
Ensure health & safety, local authority and general workshop practice regulations are strictly adhered to when using this
equipment.
Familiarise yourself with product application and limitations, as well as the speci
fi
c potential hazards peculiar to this product.
Maintain creeper in good condition. Use an authorised service agent.
Replace or repair damaged parts. Use only genuine parts only. Non authorised parts will invalidate warranty.
WARNING!
Use the creeper on level and solid ground, preferably concrete.
DO NOT
use the creeper for any purpose other than that for which is designed.
DO NOT
stand on the creeper.
DO NOT
get the creeper wet or use in damp or wet locations or areas where there is condensation.
DO NOT
clean the creeper with any solvents which may damage the paint surface or padded areas.
2. INTRODUCTION
Heavy-duty steel framework with powder coat paint
fi
nish. Easy-rolling Ø63mm composite castors with ball bearing swivels.
Vinyl covered back and headrest. Headrest is adjustable for comfort.
3. SPECIFICATION
Model no: .............................................................. SCR74.V3
Capacity: ...................................................................... 180kg
Size: (L x W x H) ...................................1020 x 425 x 105mm
Wheels: ................................................................................ 6
4. ASSEMBLY
4.1.
Screw on headrest assembly using two cross head screws (
fi
g 2 - 1) to
fi
x hinges to headrest.
4.2.
Move headrest adjustment stay to position shown (
fi
g 2 - 3). Screw bracket (
fi
g 2 - 2) onto adjuster assembly.
SCR74.V3 Issue 1 04/02/21
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Wear eye
protection
fi
g.1
fi
g.2
