GAS SPRUNG MECHANIC’S SEAT
model no:
SCR10.V2 and SCR15
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
1. SAfETy
WARNING!
Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this seat.
9
locate seat in a suitable working area.
WARNING!
Use the seat on level and solid ground, preferably concrete.
9
Keep the seat clean and tidy in accordance with good workshop practice.
8
DO NOT
use the seat
for any purpose other than that for which it is designed.
8
DO NOT
stand on the seat.
8
DO NOT
use the seat outdoors.
8
DO NOT
get the seat wet or use in damp or wet locations or areas where there is condensation.
8
DO NOT
clean the seat with any solvents which may damage the paint surface or the protective coating on the padded seat.
8
DO NOT
exceed maximum capacity of 136kg.
2. INTRODUCTION
Swivel action seat with lever operated gas sprung height adjustment between 380mm and 500mm. Padded cushion for added comfort. Seat
glides across workshop floor on five Ø60mm ball bearing castors. Base doubles as temporary tool and component storage tray.
3. SPECIfICATION
Model No:
..............................................................
SCR10
.....................................
SCR15
max. Capacity ......................................................... 136kg ......................................... 136kg
minimum Height: ................................................... 380mm ..................................... 380mm
maximum Height:.................................................... 500mm ..................................... 500mm
Gas Strut nitrogen approximate quantity ............... 3g ..................................................... 3g
4. ASSEMBLy
4.1.
If the 5 swivel castors, 5 domed head nuts and 5 plain washers are not fitted, invert the seat on to a non-scratch clean surface and fit
the five castors.
4.2.
If the swivel castors are fitted, check the fixings for tightness and tighten if necessary.
5. OPERATION
5.1.
To lower: sit lightly on the stool and lift the operating lever; the stool will lower until the lever is released.
5.2.
To raise: remove weight from seat. lifting the operating lever will allow the seat to raise.
6. MAINTENANCE
6.1.
If in constant use, check the tightness of the domed head nuts on a quarterly basis.
6.2.
Smear the castor bearings and the gas cylinder rod with a thin film of silicone grease annually.
6.3.
The castor wheels are maintenance free; ensure they are able to rotate and swivel freely.
6.4.
Clean the seat cushion and trays with a moist cloth and mild detergent.
SCR10.V2, SCR15 | Issue 1 20/03/18
Original Language Version
© Jack Sealey limited
Refer to
instructions
SCR15
SCR10
