background image

INSTRUCTIONS FOR:

ROADSTART® EMERGENCY POWER PACK

12V PEAK AMPS 1700 DEKRA APPROVED

MODEL NO: 

PBI1812S

© Jack Sealey Limited

Original Language Version

 1.  SAFETY

IMPORTANT:

 

PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE 

PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR 

PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these 

instructions, and properly maintained, give you years of trouble free performance.

PBI1812S    Issue: 1 - 30/04/14

IMPORTANT: 

To reduce the risk of a battery explosion, follow these instructions and those published by the battery manufacturer and the

manufacturer of any equipment you intend to use in the vicinity of the battery. Remember to review warning marks on all products and on 

engines.

1.1  PERSONAL PRECAUTIONS

 

Use in a well ventilated area

.

 

Ensure there is another person within hearing range, or close enough to come to your aid should a problem arise, when working near a  

 

lead-acid battery.

 

Have fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.

 

Wear safety eye protection and protective clothing. Avoid touching eyes while working with a battery.

 

Wash immediately with soap and water if battery acid contacts skin or clothing. If acid enters eye, flush eye immediately with  cool, clean  

 

running water for at least 15 minutes and seek immediate medical attention.

 

Remove personal metallic items such as rings, bracelets, necklaces and watches. A lead-acid battery can produce a short-circuit current  

 

high enough to weld a ring or the like to metal, which may cause severe burns.

1.2  IMPORTANT SAFETY INSTRUCTIONS

 

Familiarise yourself with the applications, limitations and potential hazards of the RoadStart.

 

Keep the unit in good working order and condition. Replace damaged parts immediately.

 

Use only recommended parts. To use unapproved parts may be dangerous and will invalidate your warranty. 

 

The RoadStart must only be opened and checked by qualified service personnel. 

DO NOT

 disassemble the unit for any reason. 

 

Keep children and unauthorised persons away from the work area.

 

Keep work area clean and tidy and free from unrelated materials. Ensure that there is adequate lighting.

 

If the RoadStart receives a sharp knock or blow, it must be checked by a qualified service agent before being used.

 

When not in use re-charge every 30 days.

 

DO NOT

 smoke or allow a spark, or flame in the vicinity of the battery or engine.

 

DO NOT

 drop any metal item onto the battery as it may spark or short circuit the battery, which could cause an explosion.

 

DO NOT

 use RoadStart to recharge dry cell batteries that are commonly used with home appliances. These batteries may explode and   

 

cause personal injury and damage to property.  

 

DO NOT

 charge or boost a frozen battery.

 

DO NOT

 use attachments other than those recommended. To do so may risk damage to the unit and other equipment and possible personal   

 injury. 

 

DO NOT

 pull or carry the unit by its cables and do not pull the negative and positive clamps from the battery terminals.

 

DO NOT

 operate in vicinity of flammable liquids or gases.

 

DO NOT

 recharge the unit with plugs, cables or attachments that are damaged. Replace such items immediately.

 

DO NOT

 use this product to perform a task for which it is not designed.

 

DO NOT

 store the unit in damp or wet locations or where the temperature may exceed 50°C.

 

DO NOT

 submerge the unit in water.

 

DO NOT

 use whilst under the influence of drugs, alcohol or intoxicating medication.

 

DO NOT

 leave the unit in a totally discharged state for an extended period of time as this may result in permanent damage.

 

 

DO NOT

 cross-connect the power leads from the RoadStart to the battery. Ensure that positive is to positive and negative is to negative.

 

Ensure that the unit is fully charged before storage.

 Safety Markings/Symbols

Read 

Instructions

Before

Use.

Do Not

Expose To

Rain.

Risk 

Of 

Explosion.

Caution:

Risk of 

Electric

Shock.

Use In A

Well

Ventilated

Area.

Keep

Away From

Sparks &

Flame - 

Battery 

Could Emit

Explosive

Gases.

 

Summary of Contents for ROADSTART PBI18112S






Reviews: