4-LEVEL BUMPER RACK
MODEL NO:
RE55.V6
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
9
Familiarise yourself with the application, limitations and hazards of the rack.
9
Maintain the
rack in good condition (use authorised replacement parts).
9
Keep the rack clean for best and safest performance.
9
Locate the rack in a suitable work area.
WARNING!
Use the rack on level and solid ground, preferably concrete.
8
DO NOT
overload the rack.
8
DO NOT
climb on the rack.
8
DO NOT
use the rack for any purpose other than for which it is designed.
8
DO NOT
use the rack if any parts are damaged or missing as this may cause failure and/or personal injury.
9
Keep the work area clean, uncluttered and ensure that there is adequate lighting.
9
Keep children and unauthorised persons away from the work area.
WARNING!
The warnings, cautions and instructions discussed in this manual cannot cover all possible conditions and situations that may
occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be applied by the
operator.
2. INTRODUCTION
Double sided rack for safe and tidy workshop storage of most vehicle bumpers. Heavy duty construction ideal for use in body shops. Four pairs
of height adjustable support arms for maximum capacity and flexibility. Fitted with four castors, two with brake, for maximum manoeuvrability
and safe positioning.
3. SPECIFICATION
Model No ....................................................................... RE55
Width ........................................................................ 1170mm
Height ...................................................................... 2180mm
Arm length .................................................................. 520mm
Safe working load......................................................... 160kg
4. ASSEMBLY
4.1.
Check quantities of parts.
Item
Description
Qty.
1
Horizontal top bar
1Pc
2
Vertical support bar
2Pcs
3
Horizontal bottom bar
1Pc
4
Base bar
2Pcs
5
Bumper support bar
8Pcs
6
Casters
4Pcs
7
Knob
8Pcs
8
Bolt, Washers, Nut
2Sets
9
Bolt, Washers, Nut
8Sets
10
Bolt, Washers, Nut
16Sets
RE55.V6 | Issue:2 (3) 04/06/20
Original Language Version
© Jack Sealey Limited
Refer to
instructions
