Premier Anodised digitAl tyre inflAtor
with twin Push-on ConneCtor
Model no:
sA37/96B
thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. sAfety
9
disconnect the inflator from the air supply before changing accessories, servicing or performing any maintenance.
9
Maintain the
inflator in good condition (use an authorised service agent), and keep the gauge clean for best and safest performance.
9
Replace or repair damaged parts.
Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
locate inflator in a suitable work area, keep area clean and tidy and free from unrelated materials and ensure there is adequate lighting.
9
Keep children and unauthorised persons away from the work area.
8
do not
direct inflator outlet at yourself or at other persons or animals.
8
do not
carry by the hose, or yank the hose from the air supply.
8
do not
use the inflator for a task which it is not designed to perform.
8
do not
operate the inflator when you are tired, under the influence of alcohol, drugs or intoxicating medication.
8
do not
operate the inflator if any parts are missing or the inflator is damaged, as this may cause failure and/or personal injury.
8
do not
exceed maximum permissible tyre pressure
2. introduCtion
Anodised black aluminium body with impact absorbing rubber bumper. Features auto power on/power off backlit lCd digital display
for ease of use. Calibrated in psi, bar and kPa. 0.5m flexible hose fitted with 240mm twin push-on air connector. Features a battery
level indicator, powered by 2 x AAA batteries (supplied). Supplied with a serial numbered calibration certificate. 3 year warranty.
3. sPeCifiCAtion
model no: ..............................................................sA37/96B
Range: .................
0.3 - 17.2 bar (4 -250 psi) (30 - 1720 kPa)
Accuracy: ............
5-60 ±1psi, 61-145 ±2psi, 146-250 ±3.6psi
Pressure units: ................................................... bar, psi, kPa
Inlet size: ..................................................................
1/4” BSP
B
attery: .....................................................
2 x AAA (supplied)
B
attery run time: .....................................................
400 hours
4. oPerAtion
4.1.
BAttery ChAnge
(fig.2, fig.3, fig.4)
4.1.1.
The inflator requires 2 AAA batteries.
4.1.2.
When the battery state indicator symbol (fig.1) shows empty, the
batteries need replacing.
4.1.3.
Unscrew the end cover, remove old batteries and replace with new o
nes. Replace end cover -
do not
overtighten it.
4.2.
on / off / units
4.2.1.
The unit switches on when either tyre pressure is sensed or the On button (fig.1) is depressed.
4.2.2.
To change units of measurement hold down the button (fig.1) for 2 seconds to cycle through each option (bar, psi, kPa).
4.2.3.
The unit switches itself off approximately 25 seconds after its last use.
SA37/96B Issue 1 19/08/19
Original Language Version
© Jack Sealey Limited
Refer to
instructions
fig.1
fig.2
fig.3
fig.4
