Familiarise yourself with the application and limitations of the air hose reel, as well as the specific hazards.
WARNING!
Disconnect the air hose reel from the air supply before servicing or performing any maintenance.
Maintain the
air hose reel in good condition (use an authorised service agent).
Replace or repair damaged parts.
Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
Locate and fix the air hose reel in a suitable working area, ensure that the correct fixings are used to secure the unit to the wall.
DO NOT
position the hose in direct sun light, or in areas of extreme heat or cold.
DO NOT
mount inside spray booth/oven.
Ensure there is adequate lighting.
WARNING!
Ensure maximum air pressure is not exceeded.
Keep extended air hose away from heat, oil and sharp edges.
Check hose for wear before each use and ensure all connections are secure.
Keep the unwound air hose away from wet, damp, oily surfaces.
WARNING!
Always wear approved eye protection when operating the air hose reel.
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
Remove ill fitting clothing. Remove ties, watches, rings, other loose jewellery and contain and/or tie back long hair.
Keep children and unauthorised persons away from the working area.
DO NOT
operate the air hose reel if any parts are damaged or missing as this may cause failure and/or personal injury.
DO NOT
use the air hose reel for any purpose other than that for which it is designed.
DO NOT
yank the hose from the air supply.
DO NOT
operate the air hose reel when you are tired or under the influence of alcohol, drugs or intoxicating medication.
DO NOT
direct air from the air hose at yourself or others.
When not in use ensure the air supply is turned off and tools disconnected. Disconnect from the air supply and retract the hose into case.
WARNING!
DO NOT
dismantle the hose reel casing. To do so may result in damage to the appliance and/or personal injury and will
invalidate the warranty. Internal maintenance, which will require the opening of the casing, must only be undertaken by an authorised
service agent.
InstRuCtIons FoR:
ReTRAcTAble AIR HOSe
ReelS
thank you for purchasing a sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly
maintained, give you years of trouble free performance.
1. SAFeTY INSTRUcTIONS
IMPORTANT:
PleASe ReAD THeSe INSTRUcTIONS cAReFUllY. NOTe THe SAFe OPeRATIONAl ReQUIReMeNTS, WARNINGS & cAUTIONS.
USe THe PRODUcT cORRecTlY AND WITH cARe FOR THe PURPOSe FOR WHIcH IT IS INTeNDeD. FAIlURe TO DO SO MAY cAUSe
DAMAGe AND/OR PeRSONAl INJURY AND WIll INVAlIDATe THe WARRANTY. PleASe KeeP INSTRUcTIONS SAFe FOR FUTURe USe.
MODel NO. . . . . . . . . . . . . . . . . . . . . . . SA811 . . . . . . . . . . . . . . . . . SA812.V2 . . . . . . . . . . . . . . SA813.V2 . . . . . . . . . . . . . . . . . . . . SA814
Hose length . . . . . . . . . . . . . . . . . . . . . . . .6.5m . . . . . . . . . . . . . . . . . . . . . .12m . . . . . . . . . . . . . . . . . . .10m . . . . . . . . . . . . . . . . . . . . . . 15m
Hose size ID/oD . . . . . . . . . . . . . . . .6.5/10mm . . . . . . . . . . . . . . . . 6.5/10mm . . . . . . . . . . . . . . . .8/10mm . . . . . . . . . . . . . . . . . . . 8/10mm
Maximum pressure. . . . . . . . . . . . . . . . . 150psi . . . . . . . . . . . . . . . . . . . . 150psi . . . . . . . . . . . . . . . . . 150psi . . . . . . . . . . . . . . . . . . . . 150psi
Inlet - outlet . . . . . . . . . . . . . . . . . . . . . 1/4”BsP . . . . . . . . . . . . . . . . . . .1/4”BsP . . . . . . . . . . . . . . . .1/4”BsP . . . . . . . . . . . . . . . . . . .1/4”BsP
2. INTRODUcTION & SPecIFIcATIONS
Heavy-duty polypropylene casing. Double braided polyurethane hose fitted with 1/4"BsP female inlets and 1/4"BsPt male outlets. Features auto
layering mechanism which distributes air hose evenly back into the reel housing preventing it from jamming. supplied with mounting bracket and
fixing kit for attachment onto walls or ceilings.
3. MOUNTING/ASSeMblY
WARNING! ensure the hose is disconnected from the air supply. Do not position the hose in direct sun light or in areas of
extreme heat or cold.
3.1.
Ensure that the structure to which the air hose is to be fixed is of sound construction and that the securing point will hold the working
strain of the hose when in use.
3.2.
to wall mount the reel first remove the wall mounting bracket (fig.1A) from the reel, unscrew the bracket retaining screws (fig.1B) to
release the bracket. Position the bracket on the wall surface and mark out the mounting holes, having checked that the main body will
turn sufficiently to allow the hose to be extended without rubbing on either side of the air hose housing.
3.3.
Drill your holes larger than the screws that will be used to secure the hose reel. Rawl plug the holes and screw mount the bracket
and reattach the hose reel.
3.4.
Before use, check that all fixings are safe and secure, and that the hose extends and retracts with ease.
MODel No's:
SA811
SA812.V2 SA813.V2
SA814
Original Language Version
sA811, sA812.V2, sA813.V2, sA814 Issue: 1 - 28/04/11
