WARNING!
Ensure Health & Safety, local authority and general workshop practice requirements are
adhered to when using this equipment. Familiarise yourself with the application and limitations, as well as
the potential hazards of the kit.
This kit is suitable for flaring copper, brass, steel or thin walled aluminium pipe.
Maintain the
kit in good condition.
Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will
invalidate the warranty.
Locate the flaring tools in a suitable work area, keep the area clean and tidy and ensure there is adequate
lighting.
WARNING!
Always wear approved eye or face protection when using the flaring tools.
Keep children and unauthorised persons away from the working area.
DO NOT
use the kit for any purpose other than for which it is designed.
DO NOT
use the kit if any parts are damaged or missing as this may cause failure and/or personal injury.
DO NOT
allow untrained persons to use the kit.
DO NOT
attempt to flare piping when you are tired, under the influence of alcohol, drugs or intoxicating
medication.
When not in use clean kit components, replace in case and
store in a safe, dry, childproof area.
Remember! The safe operation of a vehicle, or other
equipment, may well depend on the quality of the flare
produced. Discard any flare which is mis-formed or cracked in any way.
WARNING! The warnings, cautions and instructions discussed in this
manual cannot cover all possible conditions and situations that may occur.
It must be understood that common sense and caution are factors which
cannot be built into this product, but must be applied by the operator.
INSTRUCTIONS FOR:
ON CAR HYDRAULIC
PIPE FLARING TOOL
MODEL No:
PFT10
Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these
instructions and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE, FOR THE
PURPOSE FOR WHICH IT IS INTENDED.
FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
PLEASE KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
2. INTRODUCTION & SPECIFICATIONS
Produces accurate automotive SAE and DIN flares
on 3/16” and 4.75mm pipes respectively. Small body
makes it ideal for splicing in replacement sections of
brake pipe on-vehicle. Features a hydraulic ram
which also makes it suitable for steel pipes.
Part
Description
Dies:
3/16” SAE, 4.75mm DIN.
Original Language Version
PFT10 Issue: 2(L) - 29/11/13
© Jack Sealey Limited
