20L 3-IN-1 ASH VACUUM CLEANER
1200W/230V
MODEL NO:
PC200A
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
I
MP
PO
R
RTA
TANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
TH
HE
P
PR
O
ODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PE
ER
S
SON
NAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
1.1. ELECTRICAL
SAFETY
WARNING!
It is the user’s responsibility to check the following:
Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and
all electrical connections for wear and damage. Sealey recommend that an RCD (Residual Current Device) is used with
all electrical products. You may obtain an RCD by contacting your local Sealey Stockist.
If the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAT (Portable
Appliance
Test)
tested.
Electrical safety information, it is important that the following information is read and understood.
1.1.1.
Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
1.1.2.
Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
1.1.3. Important
: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is
fi
tted with the
correct fuse - see fuse rating in these instructions.
DO
NOT
pull or carry the appliance by the power cable.
DO NOT
pull the plug from the socket by the cable. Remove the plug from the socket by maintaining a
fi
rm grip on the plug.
DO
NOT
use worn or damaged cables, plugs or connectors. Ensure that any faulty item is repaired or replaced immediately by a
quali
fi
ed electrician.
1.1.4.
This product is
fi
tted with a BS1363/A 13 Amp 3 pin plug.
If the cable or plug is damaged during use, switch the electricity supply and remove from use.
Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a quali
fi
ed electrician.
Class II products are wired with live (brown) and neutral (blue) only, and are marked with the
Class II symbol;
A) Connect the BROWN live wire to the live terminal ‘L’.
B) Connect the BLUE neutral wire to the neutral terminal ‘N’.
C) After wiring, check that there are no bare wires and ensure that all wires have been correctly
connected.
Ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.
DO
NOT
connect either wire to the earth terminal.
Sealey recommend that repairs are carried out by a quali
fi
ed electrician.
1.2. GENERAL
SAFETY
WARNING!
This ash vacuum cleaner is for the vacuuming of cold ashes from
fi
replaces, wood or coal stoves, BBQ’s and grills.
NOTE:
Cold ash is defined as ash that has sufficiently cooled down without any pockets of hot embers.
Rake through the ash with metal tools, to check for any hot embers prior to using the ash vacuum cleaner.
DO NOT
use for vacuuming materials with a temperature above 40ºC.
▲
DANGER
!
DO NOT
vacuum hot or glowing ash, cigarette ends, in
fl
ammable, explosive, corrosive or other dangerous substances.
DO NOT
use to vacuum soot.
DO NOT
use to vacuum the following health hazardous dusts:
Class L (soft woods and solid surface material).
Class M (hard woods, board materials, concrete and brick dust).
Class H (asbestos and mould).
DO NOT
operate the ash vacuum cleaner without the
fi
lter in place. Using the ash vacuum cleaner without the
fi
lter may result in
motor failure and will invalidate the warranty.
DO NOT
allow children or untrained persons to operate the ash vacuum cleaner.
DO NOT
place the attachments close to your face.
DO NOT
point the hose end at other persons or animals.
DO NOT
leave the ash vacuum cleaner running unattended. Turn the power supply OFF when not in use.
DO NOT
operate the ash vacuum cleaner while under the in
fl
uence of drugs, alcohol or intoxicating medication.
DO NOT
use the ash vacuum cleaner in the rain or in very damp conditions.
DO NOT
use the ash vacuum cleaner for a task it is not designed to perform.
Disconnect the ash vacuum cleaner from the power supply before servicing, changing accessories, or performing and
maintenance.
Use only genuine parts and accessories. Unauthorised parts and accessories may be dangerous and will invalidate your warranty.
Recommended fuse rating
13 Amp
PC200A Issue 1 23/11/21
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Keep in dry area
protect from rain
