XPE CREE LED IntRInsICaLLy safE
fLashLIght
Model no:
LED452Is
thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. safEty
WaRnIng! DO nOt
open torch whilst in hazardous locations.
WaRnIng!
DO nOt
mix new and used batteries, nor mix different types nor mix from different manufacturers.
8
DO nOt
charge niMH batteries in the torch.
8
DO nOt
shine directly into your, another person’s or an animal’s eyes.
8
DO nOt
allow children to use the lamp.
8
DO nOt
use the lamp if you suspect that the battery or the lamp casing is damaged.
9
Remove batteries when storing torch for any period.
2. IntRODuCtIOn
Single high power XPe CRee led produces extremely bright, white light with an output of 120 lumens and a working range up to
172 metres. Two function on/off push button for high and low settings. Intrinsically safe for use in hazardous locations. lightweight,
tough and durable casing which will sustain high impacts and drops. Built-in gas release vent. Powered by 4 x AA batteries (not
included).
3. sPECIfICatIOn
Model no.: .............................................................LED452Is
led Qty: .................................................. 1 CRee XP-e led
Battery: ........................................................................4 x AA
lumen output (High / low): ............................... 120lm/ 31lm
operating time (High / low): ............................... 6hrs / 70hrs
Range (High / low): ............................................ 172m / 85m
4. OPERatIOn
4.1.
BattERy InstaLLatIOn
(fig.1)
4.1.1.
Undo lamp retaining screw, unscrew lamp unit and remove it.
4.1.2.
load batteries as indicated by internal label, replace lamp unit and reassemble.
4.2.
tORCh
(fig.2)
4.2.1.
The lamp ON/OFF/MODE button is located on the rear of the lamp (fig.2). The operation sequence is: one press provides 100% light,
two presses provides approx. 25% light, third press will turn torch off.
5. MaIntEnanCE
5.1.
Keep the torch clean by wiping with a damp cloth.
5.2.
Store torch in a dry, childproof area.
led452IS Issue 1 14/08/19
Original Language Version
© Jack Sealey limited
Refer to
instructions
fig.1
fig.2
