16W SMD EXTRA SLIM SOLAR FLOODLIGHT
WITH WALL BRACKET
MODEL NO:
LED16S
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
I
MP
PO
R
RTA
TANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
TH
HE
P
PR
O
ODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PE
ER
S
SON
NAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
Maintain the light in good condition.
Ensure the light is installed correctly in accordance with these instructions.
Only install the light on a vertical surface.
DO NOT
fi
x the light on any horizontal surface i.e. ceiling, or overhang.
Install away from
fl
ammable or combustible materials.
DO NOT
direct the light into a persons eyes.
DO NOT
install the light where it is likely to be knocked or hit.
DO NOT
install in bathrooms, shower rooms, sauna or such locations.
DO NOT
install near an exhaust outlet. e.g. Boiler
fl
ue, dryer outlet etc, or mirrored surfaces.
DO NOT
put the light in an area that is well lit at night, e.g., near a street light. This may stop the sensor from determining when it
is night time and will stop the light from operating.
The light must be securely
fi
xed to the mounting surface. The screws and wall plugs supplied are suitable for masonry only.
Mount the light level and horizontal to the ground.
Turn the light o
ff
if it is not to be used for long periods.
Locate the light away from obstructions that block the light from reaching the solar panel such as overhanging tree branches,
fences or buildings.
2. INTRODUCTION
16W Extra slim solar
fl
oodlight with wall bracket. 14 SMD LED producing 1600 lumens featuring both daylight (CIR) and motion
(PIR) sensors to switch on automatically. Motion sensor can detect up to 5 Metres. Mounted in die-cast powder coated aluminium
extra slim housing with wall bracket. Containing one 3.7V Li-ion battery capable of a run time of 10 hours and has a 30
second timer upon sensing motion.
3. SPECIFICATION
Model No: .................................................................LED16S
IP Rating: ........................................................................IP65
LED Type: ................................................................. 14 SMD
Lumen Output: .......................................................... 1600Lm
Operating Time:
............. 10 hours, 30 seconds once motion sensor activated.
PIR Motion Sensor: .......................................................... Yes
Power: .............................................................................16W
Supply: ...............................................................................5V
4. ASSEMBLY
4.1. INSTALLATION
Unpack the product and check contents. Should there be any damaged or missing parts contact your supplier immediately.
Give careful consideration to the position of unit to ensure you obtain maximum bene
fi
t from the lighting range.
4.1.1.
With care remove the wall bracket from the light assembly by unscrewing the retaining thumb screws (
fi
g 1).
4.1.2.
Locate the thumb screws, solar panel and light in a secure location.
4.1.3.
Place the wall bracket at your desired location and spot mark through the slots onto the
fi
xing surface (
fi
g 2).
4.1.4.
Secure wall bracket with appropriate
fi
xings, wall plugs, to suit mounting surface.
4.1.5.
Reassemble the light assembly (
fi
g 3).
WARNING!
If working at height take adequate safety precautions to prevent injury from falling.
LED16S Issue 1 07/03/22
Original Language Version
© Jack Sealey Limited
Refer to
instructions