INSTRUCTIONS FOR:
HIGH VELOCITY FAN
Models
HVF14 & HVF18
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
HVF14, HVF19 -(1086) - (1) 160200
1. SAFETY INSTRUCTIONS
1.2 GENERAL SAFETY
3
Disconnect the fan from the mains power when not in use, and before servicing or performing any maintenance.
3
Use the fan in dry areas only. Do not use in wet or area with high condensation such as showers, pools etc.
p
WARNING!
If a fan falls into water or other liquid, immediately switch off and disconnect from the mains power supply. Do not touch the fan
until the mains power supply has been disconnected.
3
Always disconnect the fan from the power supply when moving it from one location to another and ensure fan is stood on a level surface.
3
The fan air flow is powerful. Before using ensure there are no materials or items that may be erroneously moved by the stream of air.
3
Keep the fan clean and maintained in good condition. For electrical components or motor service contact an authorised service agent.
3
Use recommended parts only (non genuine parts may be dangerous, and will invalidate your warranty).
7
DO NOT operate the fan where there is harmful, explosive or flammable gases, fumes or hazardous substances.
7
DO NOT stand the fan on its electrical power cable.
7
DO NOT insert any objects through the fan guard.
7
DO NOT cover the fan when in use.
7
DO NOT immerse the fan in water or any other liquid.
7
DO NOT allow children to operate the fan.
7
DO NOT stand the fan where it may be knocked over or off a surface, or where the lead may cause a person to trip.
7
DO NOT use the fan outdoors.
7
DO NOT use an extension cord unless it has been approved by an electrical authority.
7
DO NOT modify speed control or attempt to fit any additional external speed control device to the fan.
3
When not in use place the fan in its original box or cover the fan to protect from dust, and store in a safe, dry, childproof location.
1.1.
ELECTRICAL SAFETY.
p
WARNING! It is the users responsibility to read, understand and comply with the following:
You must check all electrical equipment and appliances to ensure they are safe before using. You must inspect power supply leads, plugs and
all electrical connections for wear and damage. You must ensure the risk of electric shock is minimised by the installation of appropriate safety
devices. An RCCB (Residual Current Circuit Breaker) should be incorporated in the main distribution board. We also recommend that an RCD
(Residual Current Device) is used with all electrical products. It is particularly important to use an RCD together with portable products that are
plugged into an electrical supply not protected by an RCCB. If in doubt consult a professional electrician. You may obtain a Residual Current
Device by contacting your Sealey dealer.
You must
also read and understand the following instructions concerning electrical safety.
1.1.1. The
Electricity At Work Act 1989
requires all portable electrical appliances, if used on a business premises, to be tested by
a qualified Electrician at least once a year by using a Portable Appliance Tester (PAT).
1.1.2. The
Health & Safety at Work Act 1974
makes owners of electrical appliances responsible for the safe condition of the appliance,
and the safety of the appliance operator.
If in doubt about electrical safety, contact a qualified electrician.
1.1.3. Ensure the insulation on all cables and the product itself is safe before connecting to the mains power
supply. See 1.1.1. & 1.1.2. above and use a Portable Appliance Tester (PAT).
1.1.4. Ensure that cables are always protected against short circuit and overload.
1.1.5. Regularly inspect power supply, leads, plugs and all electrical connections for wear and damage,
especially power connections, to ensure that none are loose.
1.1.6.
Important:
Ensure the voltage marked on the product is the same as the electrical power supply
to be used, and check that plugs are fitted with the correct capacity fuse. See fuse rating at right.
1.1.7. DO NOT pull or carry the powered appliance by its power supply lead.
1.1.8. DO NOT pull power plugs from sockets by the power cable.
1.1.9. DO NOT use worn or damage leads, plugs or connections. Immediately replace or have repaired by
a qualified Electrician. A U.K. 3 pin plug with ASTA/BS approval is fitted. In case of damage, cut off
and fit a new plug according to the following instructions (discard old plug safely).
(UK only - see diagram at right).
Ensure the unit is correctly earthed via a three-pin plug.
a) Connect the GREEN/YELLOW earth wire to the earth terminal E.
b) Connect the BROWN live wire to live terminal L.
c) Connect the BLUE neutral wire to the neutral terminal N.
After wiring, check there are no bare wires, that all wires have been correctly connected and that the wire restraint is tight.
Double insulated products are often fitted with live (BROWN) and neutral (BLUE) wires only. Double insulated products are always marked with
this symbol
To re-wire, connect the brown & blue wires as indicated above. DO NOT
connect the brown or blue to the earth terminal.
1.1.10. Cable extension reels. DO NOT use an extension lead unless it has been approved by an electrical authority. When a cable extension
reel is used it should be fully unwound before connection. A cable reel with an RCD fitted is recommended since any product which is
plugged into the cable reel will be protected. The section of the cable on the cable reel is important. We recommend that at least
1.5mm
2
section cable but to be absolutely sure that the capacity of the cable reel is suitable for this product and for others that may be
used in the other output sockets, we recommend the use of 2.5mm
2
section cable.
Blue
Neutra
l
Yellow & Green
Earth wire
wire
restrai
THIS PRODUCT MUST BE
FITTED WITH A:
3
AMP FUSE
Brown
Live
wire
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS AND CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS
INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY.
PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
