1. SAFETY INSTRUCTIONS
2. INTROdUCTION & SpECIFICATION
WARNING! Ensure all Health & Safety, local authority, and general workshop practice regulations are
strictly adhered to when using product.
Maintain tools in good and clean condition for best and safest performance.
Wear suitable clothing to avoid snagging.
dO NOT
wear jewellery and tie back long hair.
dO NOT
use this tool for any purpose other than that for which it is designed.
Keep children and other unauthorised persons away from the working area.
dO NOT
point at other persons or animals.
dO NOT
operate if you are tired or under the influence of alcohol, drugs or intoxicating medication.
When not in use, remove the tacks from the magazine and store in a safe, dry, childproof area.
instructions for:
CAblE TACkERS
Model n
o's
:
CT610 & CT8125
thank you for purchasing a sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
IMPORTANT
:
plEASE REAd THESE INSTRUCTIONS CAREFUllY. NOTE THE SAFE OpERATIONAl REQUIREMENTS, WARNINGS, ANd
CAUTIONS. USE THIS pROdUCT CORRECTlY, ANd WITH CARE FOR THE pURpOSE FOR WHICH IT IS INTENdEd. FAIlURE TO dO SO
MAY CAUSE dAMAGE ANd/OR pERSONAl INJURY ANd WIll INVAlIdATE THE WARRANTY.
3. OpERATING INSTRUCTIONS
Original Language Version
ct610 & ct8125 issue: 2 - 22/03/11
CT610
- Heavy-duty cable tacker. two staple guide plates and two sizes of staple allow the tacker to be used on
cable from Ø4mm to Ø8mm and on flat wire of 2.5 to 6.3mm thickness. supplied with 100 cable staples. suitable
for a wide range of electrical installation tasks.
CT8125
- Heavy-duty cable staple gun. three staple guide plates and three sizes of staple allow the tacker to be
used on cable from Ø8mm to Ø12.5mm and on flat wire of 4 to 7mm thickness. fitted with adjustable pressure
control. supplied with starter pack of 200 cable staples. suitable for a wide range of electrical installation tasks.
3.1. lOAdING CAblE TACkS
3.1.1. Always keep cable tacker with the exit hole facing away from you, preferably towards the surface, to
which, the cable will be tacked.
3.1.2. release loading spring by pressing the release button downwards (fig.1), always secure cable tacker
and be weary of the spring extending from the loading slot.
3.1.3. once the tacks are loaded in the loading slot (with the points facing downwards towards the base)
reinsert the loading spring (fig.2) and clip the release button back into place.
3.2. USING THE CAblE TACkER
3.2.1. Grip the tool firmly and push the cable tack exit against the cable to be tacked and squeeze the trigger.
3.3. INCREASING pRESSURE (CT8125 ONlY)
3.3.1. if you are tacking cable to a harder surface, simply move the pressure switch to increase the pressure
which is used to drive the tacks in (fig.3). it is recommended to use less pressure on a less robust
surface.
