VS819 - 2 - 030206
INSTRUCTIONS FOR:
BORE SCOPE (600MM)
MODEL NO:
VS819
Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE
PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY
AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
!
WARNING!
Ensure Health and Safety, local authority and general workshop practice regulations are adhered to
when using tools.
"
DO NOT
use the bore scope if damaged.
"
DO NOT
point the Distal Tip towards the sun, or view bright light sources. Permanent damage to your eye may
occur.
$
Maintainthe bore scope in good and clean condition for best and safest performance.
$
Ensure that a vehicle which has been jacked up is adequately supported with axle stands.
$
A full range of personal safety equipment is available from your Sealey dealer.
$
Wear suitable clothing to avoid snagging. Do not wear jewellery and tie back long hair.
$
Account for all tools and parts being used and do not leave any in, or near, the engine.
$
Be alert to your surrounding environment while using the bore scope.
1. SAFETY INSTRUCTIONS
2. INTRODUCTION
3. SPECIFICATION
Suitable for internal inspection of cylinder bores, engine components and other machinery/industrial applications.
Flexible 600mm shaft can be bent to shape to fit through small apertures and around obstacles. Subject illumination
is provided by two LEDs which are controlled by a three-position switch, giving low output, full output and Off. LEDs
are powered by 4 x AA batteries (supplied). Adjustable eyepiece allows user to tailor optics to suit their vision.
Supplied in a carrying case. There is also a mirror accessory supplied in a polypropylene container of 3 cms diameter
and 4 cms high. This accessory is shown in Fig 3 and connected to the bore scope in Fig 4.
1
Model No: . . . . . . . . . . . . . . . . . . . .VS819
2
Shaft Length: . . . . . . . . . . . . . . . . .600mm
3
Probe Diameter: . . . . . . . . . . . . . . . .10mm
4
Viewing Angle: . . . . . . . . . . . . . . . . . . .40°
5
Viewing Distance: . . . . . . .10mm to infinity.
6
Bending Diameter: . . . . . . . . . . . . . .76mm
7
Tip Diameter: . . . . . . . . . . . . . . . . . .10mm
8
Batteries: . . . . . . . . . . . . .4 x AA (supplied)
9
Housing Material: . . . . . . . . . . . . . .Nylon 6
10
Mirror Accessory . . . . . . . . . . . . . .VS819M
Fig 1
