1. SAFETY INSTRUCTIONS
2. SPECIFICATION
Model No. . . . . . . . . . . . . . . . . . . . . . . . . TH003
Max. Load. . . . . . . . . . . . . . . . . . . . . . . . . .200kg
Wheel Diameter . . . . . . . . . . . . . . . . . . . .250mm
Trolley Wheel Width . . . . . . . . . . . . . . . . . .90mm
Height . . . . . . . . . . . . . . . . . . . . . . . . . .1520mm
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
Fig.4
Pick up and transport stacks of car tyres with ease. Strong tubular steel construction with welded joints. Pneumatic tyres allow transportation
over rough ground with swivel castors for stability and fulcrum purposes.
INSTRUCTIONS FOR:
TYRE TROLLEY 200kg CAPACITY
MODEL No:
TH003
Fig.3
Fig.6
Original Language Version
TH003 Issue: 1 - 10/04/13
© Jack Sealey Limited 2013
3. PARTS
WARNING!
Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using
this equipment.
Always load centrally and evenly with the tyres registering with both load bearing uprights in the transport mode.
DO NOT
overload the trolley - see Specification.
DO NOT
leave unattended, especially when loaded, unless the wheels are chocked or the trolley is otherwise secured.
DO NOT
run over curbs or steps, use a ramp.
DO NOT
allow others to ride on the trolley.
DO NOT
use the trolley if any parts are damaged, paying particular attention to the jaws.
Item Part No
Description
Quantity
1
Stub axle and mounting frame
1
2
Swivel castor frame
1
3
Handlebar and lever
2
4
Adaptor tubes
2
5
Jaw
1
6
Jaw (opposite hand)
1
7
Adaptor tube collar
2
8
Handlebar grips
2
9
Tension spring
2
10
Pneumatic wheels
2
11
Swivel castors
2
12
Hub cap
2
13
Angle adjustment bar
1
14
"U" bolt
2
15
Clamp plate
2
16
Hex screws M10 X 16
8
17
Hex stiff nut M10
8
18
Plain washer Ø10
8
19
Hex bolt M8 X 45
12
20
Hex stiff nut M8
12
21
Plain washer Ø8
12
22
Handlebar plug
2
Jaw sweep and lift
levers (with grips)
Transport handlebars
and stack support
1
2
3
4
5
6
7
7
8
9
10
11
12
13-15
22
2
1
Operator side
Fig.5
Fig.1
Fig.2
